Hello, the following problem: due to completely unloaded power supply battery, there were a lot of error entries in different control units. I have charged the battery again and usually everything is running again. Not this time: The message “Please selector lever on position P” does not go out. The selector lever is on position P, the display “P” on the gearbox choice also lights up red. I had this before, especially in cold weather. A repeated jerking had created a remedy. Not so now. Because he does not recognize the position P, he does not allow a motor start, nor can I pull the key again. Do you have an idea? Thank you and greetings. Phaeton is automatic, BJ 2004, 3,2l Here is the extract from the scan: ______________________________________________________________ Address 05: Access/Starter. Label file: PCI\3D0-909-13×05.lbl Control unit part number: 3D0 909 131 T HW: 5WK 470 21 Component and/or version: Kessy 6120 Coding: 0000232 Operating number: WSC 01065 0 00 00000 Advanced information: XXXXXXXXXXX ELV XXXXX Advanced information: Geraet 00000 VCID: 326F5B83D4BF Error codes have been deleted. 1 error found: 6 – Terminal 15 006 – Short circuit after Plus _____________________________________________________________