Hello, for some time now my Opel Vivaro B has caused me problems. Running power 196000 Km. Since last summer the car starts to throw out the error P0106 after the warm-up drive. And if I don’t take the gear out and start the start stop comes also the error exhaust system check. If I stop in time just before the start the gear out the error goes away. I run the engine remains the error and then follows exhaust system check. The cruise control is then also n This is the absolute pressure sensor / barometric pressure sensor suction tube circuit. The MAP sensor / charging pressure sensor has been replaced by 3 compartments. Thus, it should not be. The charging air hoses have been renewed. All injectors have been replaced. The air volume meter has been renewed. A new AGR has been installed. So far 2 candles have been renewed. The new AGR has been re-installed. The error code is no longer available. Since the error comes and goes, and I sometimes don’t even have to delete it, I think it’s not a mechanical problem. Rather an electronic one. I was against my screwdriver. I don’t know anymore. And I don’t. Can someone give me helpful tips? The Vivaro is identical to the traffic, Primestar etc. Engine runs, no noticeable line loss. slightly increased consumption , about 1 Maybe someone has an idea and can help. Thanks in advance. Greetings Michi