Hallöle, since I finally started this WE with my new conversion, I want to put the whole online directly. First of all the IST recording: – not soo fitting – too high double ground (because of Powercap) – side parts not foldable, if bottom plate in it – final stage on the side part Here are the photos:http://img112/60/PICT1364Large.jpghttp://img112/60/PICT1366Large.jpghttp://img112/1751/PICT1365Large.jpghttp://img112.imageshack.us /img112/3741/PICT1368Large.jpghttp://img154.imageshack.us/img154/489/pict1369large5sk.jpg I wanted to fix all the flaws. The powercap comes behind the left side part, both power stages below the ground, the double floor thus deeper and the whole at all a bit more fitting. Furthermore, the cables should be reasonably located. Here is what happened so far The new base plate, much more fittinghttp://img143.imageshack.us/img143/8620/pict1373large2dn.jpghttp://img154.imageshack.us /img154/6425/pict1374large8nc.jpg So later the power stages should lie. The lower with the power terminals to the side part, because behind it is the cap. The other with the terminals to the right, because the speaker cables otherwise do not suffice http://img154.imageshack.us/img154/619/pict1376large2zc.jpg Here the whole with the foldable side partshttp://img143.imageshack.us/img143/9396/pict1377large8qh.jpghttp://img154.imageshack.us/img154/4341/pict1378large5yw.jpg The supports for the ground I will put t even tinker. In addition, the whole substructure is also covered with felt. To be continued