Hello dear community. Well my question. I have 2 original Keyless Go cards from a Renault Espace 4 Built. 2007 a card there was the shell broken and I opened it and then I lost original pill, so I got a replacement pill and a new shell. Now I’ve got the card where the pill was gone so far that I can drive with both cards, but my Keyless Gound the central transmission is not possible. According to the Can Clip, 2 cards are read in, but at the Key less Go stands 0 How can I add the cards to the Keyless Go? I have Renolink, DDT4All, Renault Can Clip from 159 – 237 in my online shop and other brands, but I would like to lock my car again, the funny thing is that when I go shopping and come back then the car is closed and I just have to grab the door handle on the driver’s side and pull it short and all doors open, but not every time. I have Renault Pin calculator. I just don’t have out yet found how to do exactly with the Renault Can Clip, add the cards or learn. Battery, I separate after every time work in the system. But here in the forum there is also a contribution to the cold soldering point in the UCH and that the contact of the ZV / Keyless Go permanently press on because sensor and there he made a cable tie in between, because also with me, it looks as if on the driver’s door the button is pressed permanently by the sensor, because the plastic i my sensor is already through in the driver’s door, so I got another sensor and I will equip the contacts in than door handles inside with new cookies and then see if what brings or not a cold soldering point is the problem. Just the question why the card with the number C398081D (ident. badge available 433 Mh/z transponder type 7936 says and on the map: 39462D16 (ident. badge available 315 Mh/z transponder type 7946 or 47 – although there is also a T ransponder 7936 AS is in it. Greetings Kalle