Hello, I bought a Lupo 1.0 from 2004 a few days ago (Motor AUC) This was also normal at the beginning, but when I started it 2 days ago, it ran in idle after about 10 seconds and then went out after about 30 seconds. If you start the engine again, until it gets a bit warm, the problem also resolves and it runs quite normal as if nothing had been done. So the problem only occurs, so to speak, when it is cold. Do you have an idea, wo s the problem could be? Have already ordered new spark plugs & also ignition cable plugs since a plug is oxidized (see video) These should arrive in a few days. But you should notice directly that it can’t be because of it, I would be very grateful, then I could solve it faster. Error memory was read out – NO FEHLER PS: I uploaded the videos to Youtube because I couldn’t attach them right here. Hope that’s ok. Video from the ignition cable: htt ps://youtu.be/G3QwcSCpdgQ Video where it ends: https://youtube.com/shorts/W8qf_9GLhrE?feature=share Thank you so much