Hi Lupo Founde I’ve already read almost everything in the forum about the Lupi3l of diseases! Only this problem that exists with me apparently nobody has. Have a Lupi 3l bj 2000 213,000km all service at VW I initially had the problem that he didn’t want to start again after putting it off no matter whether in e or in n always noticed all specifications door to brake kick etc. Then I set the clutch value and carried out the basic setting everything best ns kalppt,then I could drive again except that I could only start in N. But I already had the problem about 1 year. Since my hydraulic pump and my gear controller were oiled and you could not exactly see where it came from I was at the wash road and I radiated the gasket and the hypump.After that I drove about 2km and then I stopped to bring the engine to operating temperature because I wanted to see if the temp generator is defective. The temp generator is i .o Then I made the stage E in there he didn’t do it at first!Speed went up and he didn’t drive a meter in R exactly that same and over tip also nothing.Then I put again E in then he jerked 2 times as if he wanted to insert the gear but something prevented him from doing so. So I turned off the engine. Yes and then that was it,Then I switched on the ignition again and the gear indicator in the gear insert shows absolutely fahlsche gears. In P stands 5 that’s normal In R stands 5 In N stands 5 In E then it comes switch bar in the speedometer and it stands on N In the tippgasse it stands then at times 5 times 3 times 1 If it stands then I can not start then however also unfortunately. If I start the selector lever very slowly from E (choose lever position)tacho indicatorN)high slide it also airs over R only that are mm. Error code Gearbox:Ber for gear speed(G38) 03-00- no signal I checked all plug connections after humidity everything dry G38 I removed and d because giver held to metal no difference. Mistake remains firm and can be deleted ncitht. icht can help me because I am at the moment with my knowledge at the end. In the grunt setting he does not go in, I think because of the wrong gear selection. thank you.