Hello dear Mini friends, I got a new passenger door because of a shunting accident. When I was able to pick up the mini after the repair, I didn’t really see it! The door had a loose 1.5cm distance from the car. At the top of the door was also so 1cm from the escape from the car. The Procar Köln Nord BWM employee said this was so. A tolerance would always be there. It is never possible to get as in the origin… ??? And because the parts are manufactured in England and the Engl Well, I thought BMW Mini was a premium manufacturer… Is that really so? Yes, the door was then adjusted afterwards by the workshop and it doesn’t stand out any more, rather a little bit in and the savings measures could be balanced. The door presses the seal now very firmly in… 6 men were in the gray latzhosen. I also thanked the men after the setting but strangely, no reaction came… I h But I’m only 70 percent satisfied. The door will certainly sit down… Should I take it that way or what else can I really do? But how can I release the car for the customer with such a result? The expert didn’t see the damage as a loss because a new part is being installed. But if the new part of the car is not pushed or something like that, then it will look better and you’ve done your best, what can I say and do? If it’s a fake, don’t you believe me that it was done in a BMW contract workshop… did any of you have to have such an experience?