Hi Here’s what I have to do with a 2e power amplifier … But I now have an existing 16mm2 cable in the car that would not be enough for both power amplifiers … Since it was pretty bad … the 16er was moved in then and the two holes in the spray wall are too small for a 25er I would now like to draw a 2es 16er cable from the same screw on the battery for the 2nd power amplifier …. In principle as if I did not pull the fuse manifold block 1×25 to 2×16 in the boot in front of the power amplifiers, 2x 16mm” cables, each secured with 60A, one per end stage, so they are NOT switched in parallel) mass point for both power stages is of course the same… Can I do this without troubles or are there bad surprises to expect? Lg