Hello everybody, I have been reading silently for a while. Now I have a question and hope for your advice. It’s about my Toyota Carina E, BJ 1996. At the TÜV control it was found that the parking brake does not pull right back. In addition, the brake in the rear left strongly grinds. Lever path Hand brake also too long. Measurement values Parking brake left: 120 daN right: 30 daN Measurement values Operating brake in the rear left: 180 daN right: 170 daN As far as no drama is concerned, the brake will stop Yesterday, I was in the workshop to order appointments and parts. In my opinion, the costs of more than 500 € are a bit too high. Repair expenses: – Pads Drum brake on both sides – set-up kit on both sides – brake cylinders on both sides – brake fluid change – accessories incl. maker’s wage The service employee did not open or look at the brake. All parts were ordered and according to his statement, what is installed is what On my request, whether new brake cylinders (last change 01/2011) as well as new brake fluid (last change 01/2013) are absolutely necessary, was answered with yes. How do you see the set up for the parts? Can this fit or will probably try to sell parts are not necessary? Repair date is this Saturday, car will be delivered Friday afternoon. Would be nice if I could get some opinions from you by then. Greetings Mario