Hello, I have a trivial, but for me annoying problem with my navigation (version 0BC2): After reaching the target, always after restarting the car on the display, a hint appears that a target point is set and still some blablaze. This is annoying insofar as the display is filled out for some time and e.g. the image of the return camera is hidden. You have to press Exit – each time. I have not yet discovered a manual termination of a route guide, you can go back. nn just interrupt them – but that doesn’t solve the problem, because the target is still stored and the message still pops up again and again. The only possibility, according to my knowledge, is to delete the navigation or user data completely. However, this also disappears navigation history, stored targets etc. As I said, it is annoying and I have not yet experienced a navigation system that is so user-unfriendly. Or have I just overlooked something en? For a tip, how to make sure in navigation that after reaching the destination the route guidance is actually completed or how to finish a route guidance manually, I would be very grateful. Thank you!!! Dear Greetings, bukowski3008