Hello you love, and indeed I have already asked in another forum for help but since we are probably now at a point where nobody knows anymore because I thought I tried it here again maybe comes a new thought or the like. And I have already several problems, because my escort always makes problems for a few weeks at the cold start again, he orgs without end and so after determined 10 seconds he makes then the first “start cough” un d then you can see how slowly one cylinder ignites after another and then it runs slowly round, but the whole takes quite a while, and until it runs round, it squirts (white) extremely. I can achieve the round running faster, if I give a little bit of gas in idle, then it takes much less time as in stationary gas. Glow candles I replaced last weekend with Beru candles. Since the question came how much tension because on the glow candles I have the measured times and achieved the following result: glow candle 1 10,30 V glow candle 2 10,90 V glow candle 3 10,80 V glow candle 4 10,50 V I tested the glow candles from left to right. Since the Yes is perfectly fine, I also checked the battery immediately, this one has in the rest mode (if only radio is running and nothing else) around the 12,5 V then I have also seen how much it loses during the pre-glow and the start, I have measured this also and there again this e Results achieved: Battery in the ”Quiet mode” 12,73 V battery after the pre-glow 12,43 V battery after the start 10,43 V So this shows me that the battery is perfectly in order and since the glow plugs are perfectly in order I don’t know anymore. Oil is still 10w40 but soon will change in 5w40. But don’t think it’s just because of it! Greeting and thanks in advance Tobi