hello and I have the following problem with my tweeters: I read in there once and wanted to clean the tweeters into the a-pillar full of elan. I wanted to take n old t-shirt, and span over the wooden frame and the a-pillar, and water with resin. then another layer of gfk over it and then spat on it and then grind. only that is a bit stupid at punto. and indeed the tweeter has to be relatively far away from the a-pillar. and if you would then put a cloth over it. , the opening would also be covered by the t-shirt. on the side of the driver this works without problems, since the tweeter should also show on mic hzeigen there, and thus is relatively flat on the cover, there are therefore no problems. how should ic hdas jez do on the driver side? have already thought about not only making n ring on it, but so a kind of plate, which one then sees from the front. how would you do that? here still pictures:http://img201.imageshack.us/img201/1631/img0019xw4. jpghttp://img197.imageshack.us/img197/7415/img0020rf1.jpg