Hello, I had my FSI with feathers (40/40) lower in a workshop and now is rather higher than before (at least in front). I attached a picture of it. Since I don’t want to leave it that way and the feathers are apparently total scrap for lowering (driving behavior is better than before) I immediately ordered new H&R springs by COD yesterday after terrible sight and the pick-up, which I have in 3L (is also 6E) to fix this again quickly l The sight was shocking yesterday after reaching the workshop. I only thought: “What is that?”. The feathers are from a dealer and are from the house “AP”. I said explicitly for Lupo 6E when ordering by phone. Actually I have always been against exotic manufacturers who are not so well known but this time I just tried it out (should be a German manufacturer) and ended up completely beside it. When unpacking the feathers I was too t also skeptical because the rear spring had 9 coils and the front 12. In addition, the included report was only for 6X and 6ES! So I called the dealer again before the installation and he only said that they fit nevertheless. In addition, in the included invoice also stood for “6E”. After I saw the result yesterday, immediately then called the dealer and mailed him a picture of the thing. I get the money back for the springs when they next at the end next I guess it’s because of the other axle loads that the seller didn’t pay attention to. The description was clearly “for FSI”. I’m glad to have bought now reasonable ones in my 3L. So I know what I have. Lg, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan, Jan