Hi people, have the following problem: The 850 from a friend no longer starts (not WFS) and you can’t say no… Before I look for a wolf I just wanted to listen to you. First of all: I don’t have a chance to query the fault memory and would like to drag the car to the dealer of my (non)trust… Problem expresses itself like this: No spark (also not directly to terminal 4 of the ignition coil), injection valves have power supply, but are not switched against mass and thus do not inject. Therefore I think that a def. crankshaft encoder is obvious, isn’t it? Resistance value is 293 Ohm, however the AC voltage signal at starter speed is only 0.25V (had only a multimeter to measure; hope that was not too sluggish). What do you think about this?