Servus @ all The work has managed, my toy is dry in a heated hall and I have already removed the interior of the cabin…. The plan: Demonstrate everything except for frame and drive, radiate sheet metal parts and then paint in robust matte black. Frame and paintable drive parts by hand with tape paper and co. and then bring brush and roll into a durable condition. ……. Here I am, at the roll bar. Since I have found the most diverse statements in the net, a question to those who have a clue! What I think now!: The overroar is considered a fixed load as long as it does not change the external dimensions of the vehicle to the side. To the top it may not look ???? beyond the cabin! I want to bend in the company two 80s pipes in the form of the cab and one after the other with a Flat iron should be screwed as a foot to the loading surface edge. To the rear, a foot made of 80 tubes should serve as a slanting support on each side and also be screwed to the top of the loading surface edge. Here, the recording holes held in the loading surface wall should be used (don’t know what they actually are for). On the supports, a kind of handrail should run from 80 tubes up to the rear holes. On the top of the handle, 4 headlights, of course seperately switched. because from your experience something against it and is the whole really admission / registration free? Add a rough picture of the planned handle! Thank you!