Hi guys, so it’s time to change my rear tire. On the advice of various grey eminences here in the forum, I shot a Dyna rim in the bay. With 4.5 x 17 and a 160 pneu, that’s the limit of what can be done on my softail without cutting off the frame booms. Although I’m still tinkering with how to get the thing done with the fender fixture, but I’m sure there’s something else (thread bundle jacks, screws from the inside, etc.) Currently I have jedoc h the question, how do I get the pressed-in bearing out of the rim. As I see it, two bearings are pressed in from each side and in the middle in between is one, h, let’s say axle spacer in between. Problem: I have a 3/4″ axle, the current bearings however have an inner diameter of 25,4mm, so exactly 1″! How tight are the bearings in there? is that an h7 fit or what comparable? I think I can get them out only with a pull-out tool, right? But how The spacer lies flush on the inside of the bearing ring, so that the claws of an ausciher cannot grip. And chase through, the whole axis does not make sense either! Who has done this before? Is there a simple solution (not visible to me at the moment)? … except to go and let it be done !!! Well, I need the suitable spacer anyway, but I just want to get the parts, but do the work myself. Thanks and Greetz Bis then str Eet-jumper