Hello I have a Wolf Scooter sv4 and recently the following problem that the mower is in position when the scooter is up to power I assume that the coupling works but when I mow the seam turns too slowly and takes no power on who can help me
Author: 00c12f
-
Tractor cannot be pushed
Hello, I have a problem with a tractor Deutz D25. I want to push the tractor only about 5 meters. Unfortunately, it can only be moved as far as with a car where the handbrake is tightened. I take the handbrake is the bar which is circled in. (Presses down at least on the right pedal) It can not be moved no matter how I adjust it unfortunately. I can not drive it away because the battery is empty. So a tractor has to be moved anyway? What do ic Thank you very much.
-
Tecumseh TVXL 170 outlet valve does not open
Good evening, I bought a used (defective) lawn tractor today. Ulky part, I don’t even have an idea of which brand the device is, at the front of the “engine hood” stands only in green writing Spider. The engine (a Tecumseh with 7hp, I suspect TVXL 170) does not start, the reason is probably that the outlet valve does not open. The shock (or whatever the exact name is) behind the valve lid does not move. fnet and closes wonderfully. I am honestly not the over-screw, but I would like to try the repair. How do I proceed now best? Has someone possibly had a similar problem or an idea where the defect might lie? With a few pictures of the engine, the tractor in whole I unfortunately did not photograph, but I can gladly submit if necessary. Greetings Woerschtel
-
997 FL Cabrio – can be bought / sold as a switch
Hello municipality, I have a question for those who have been dealing with Porsche 911 for a long time or longer: so far I had and have had many Mercedes’e as well as more than a few old and youngtimers in the fleet. But I was offered a 997 (Facelift) convertible in the circle of acquaintances, from first doctor’s hand. The vehicle is perfectly maintained check booklet and in a very neat condition, I looked at it last week and I also drove it sample. My question now: Myself is not interested at all, that has a manual transmission, to which he has very short switching distances, because I have still other cars and will not drive very much with it. But it is just a cheap offer, but I do not want to, if I will sell the car again in the future, stand before the problem, that as a switch then no one wants to have it then ??? I asked in my acquaintance circle, who told me that exactly this car from the year of construction (2009) a very tol Is that true? Thank you very much, if one or the other between the years can give me a short feedback on my question. I don’t need the tip to simply drive one with automatic, but I don’t need it, because I only buy the (possibly) now, because it is from 1st hand (also no demonstration car was according to letter) and a cheap offer, otherwise I wouldn’t have a elf z we want to buy time, because I have enough cars. But one should certainly not miss an opportunity 😉 Thank you and nice celebration/holidays
-
Since 2021 No more testing necessary?
Hello, since August 2021 no local customer test is necessary in Munich anymore. Is a small test necessary or? If yes, what do you have to know and then you have to transport the customers with’m Navi? Thanks in advance.
-
Hydraulic coupling venting problem
I found out that the liquid flows under the receiver cylinder. Everything was taken apart and the old liquid removed. Now I wanted to make new clean, I’m really sure that the screw and the hole for the hose are parallel, but the new liquid just doesn’t want to go in? What’s that about? LG and thank you
-
Motorcycle does not start, ignition coil problem
Hello everyone. Actually I come from the Yamaha corner. A friend has inherited a Honda CBF 600 SA, which stood about 3 years. Now she is standing with me to finish her TÜV. Since she ran modestly and took bad gas, I removed the carburettors and cleaned them. So far everything was good. A week later she jumped again bad. Shortly after that no longer at all. Now I pulled in the schematic and searched the Rep. book. After that should actually be on the ignition coil. f a cable 12V and on the other mass. But I can’t measure anything. Today we spent 5 hours limiting the error, but did not come to any result. Maybe someone still has a TIP.
-
Oldtimer for TAXI approval sought
Hello dear municipality, thanks to the powerful car lobby, it has been legally mandatory for more than 5 years to use only factory-made taxi vehicles for the registration of a taxi. Before that it was feasible to convert used vehicles to taxi, now it is necessary (usually) a sogen. Certificate of conformity, which e.g. for oldtimers are not created. Only possibility – because of the inventory protection – would be the (re)commissioning of a before – or always noc h – registered taxi vehicle. If someone still knows a (immediate) registration possibility or knows how to buy an old taxi, I will gladly pay a good brokerage commission if I succeed. Thank you for your efforts and greetings, Mike.
-
Chain set completely assembled by the dealer
Hello, I have today, since I do not yet have a “trust” workshop, picked one out and found out on the phone, that for my Honda (PC32 from 1999) a chain set with tickles should cost 200€ and another 105 € labor costs. That is then about 300€. Is this a normal price? I mean ok, it is a workshop, which probably original honda parts are installed. Winter works grant 25% according to their statement, since we are at about 75€ work wage for 1.5 hours. But 280€ for a chain set I think it’s all right, especially since I’m not sure if it would be enough to tighten or renew the chain. The dealers always want the full program right away, of course, you finally make money.
-
Helmet release
Hello, I can’t handle the helmet. As soon as I put on the helmet I don’t feel comfortable especially in the city. On the highway is no problem. What do I have to do. Go to the special doctor or how ?