So hello I have a question in general about Mazda… and I want to get a car soon, and I found a Mazda. Only the problem is that I don’t know how it looks like with the MArke. So the cars are generally very repair-prone, or is that okay?! That said car would be a MAzda 323F (or so) with 65 kW… trailer clutch and disc roof, with 119,000 kM on it at a price of 2.990,- So I thought that I might still have the price n bit d Thank you for the answers.
Author: 00c12f
-
Final stage installation for subwoofer operation audi A4 b8 Bj 2011
Hello dear community! So I’ve read a lot here on this topic. Nevertheless, I would like to ask again to get a clear statement to the point. So here’s my question: Is it correct to operate a subwoofer that I connect the power amplifier to the battery in the trunk (is yes logo) and I get the required signal so that the subwoofer does its work easily from the box cables in the left compartment in the trunk? Have already got here the occupancy of the pins found. Then I just put a cable to what I connect to the high input at the power stage and then it should run? I know the topic has been chewed through but I still ask you to give me a concrete answer and not left to other thread’s. I would like to thank you already!!!
-
Boxing cracks with bass – end stage set wrong or boxes broken?
Hi, my system is running now. have the Focal 165V Slim Line inside ( 60 Watt RMS ). They are fired with a bridge QM75.2 with 2×75 RMS. Now I tried the system once and the power amplifier uahc net wide open. On the radio I heard first normally, everything is fine, but when I turned up a little bit wide, so funny cracks came. Just like a short bang in the middle time again and again. But that also only with one song where the bass is a little more violent or deeper. ed goes all the way. So far my amplifier runs so that it lets all frequencies through. If I turn on the filter, so only play from a certain frequency range upwards, then it sounds ok, but then there is hardly any bass. have only d2 modules so far for it. Once 130Hz and once 250Hz. What could be that and which frequency module would be the most suitable ? 80Hz? Or is the 130Hz model the best? I just wanted to have some kickbass mfg Fishly
-
Aerotwin wiper
Hello to all Mazda 6 riders, thank you all who gave me the tip with the Aerotwin windshield wipers…They are really great…For those of you who want to upgrade them, this one is available at the Amigo car part (in the I-Net), the type designation is “A 728 S” are actually intended for the Ford Focus, but fit as a retrofit kit to the Mazda 6!!
-
OBD diagnostic device
Hello and already happy Easter, I am looking for an OBD diagnostic device. Currently I have and use an OBD Eleven, for VAG vehicles you can do a lot with it… I don’t want to buy a VCDS anymore. However, since there are still Renault vehicles in the household, and BMW, Opel, Fiat and others in the familiar circle, I would like to have a device that covers the most common brands. It should be able to read out and delete beside errors of the ECUs absolutely: great would it be if it could read out the FIN of the vehicle and program tire pressure sensors, but that is not absolutely necessary. A standalone device would be better for me than one for which I still need a laptop. The device should as far as possible not cost more than 1000 €. Does anyone have experience with it? Is the price dream idea or is there anything there?
-
Problem after a diagnosis
Hello everyone, I have already tried to find my problem infos, try here too. I ordered (to solve a catalyst problem,) a cheap diagnostic cable from China. The broadcast arrived with a corresponding CD with a diagnostic program for Win XP. After the Kat problem was solved I tried to test further diagnostic possibilities from the program and clicked on the button “Output Test”. Unfortunately the test could not be completed because the program crashed. I turned off the ignition on the car and shut down the Pc. And the next day after the engine start I noticed that the power steering is not working, the steering wheel is difficult to turn (servo symbol lit after the engine start). Could it be that during the test a mistake has crept into any controller in the car? Where can I get help? If I go to a car workshop, they will take me seriously if ic h tell about the incident? Where can I have the mistake coded away again?
-
Painting with spray can does not cure, why?
Hello, 2 weeks ago I primed, spat, primed, then applied base varnish and clear varnish in several layers, always let it dry in between. Now I wanted to polish, but the polishing worked in the varnish and the varnish becomes dull. Then I wanted to pick up the polishing with spirit (not nitro thinning), then the clear varnish peels. How can the lax spirit dissolve the clear varnish after 2 weeks, what happened there? MfG C hris
-
How satisfied have you been with your dealer?
I’m just asking you how happy you are with your workshop or dealer. I’ve only been in the workshop so far and they’re pretty fast on the money, so first of all opder look so or generally or that they just do something about kulanz. But there’s the workshop of Autohaus Wabbel worse to call than ATU. There I drove and he looked at the car right away and told me what the mistake is, Mazda says first Ter So there’s no guarantee the customer’s king.
-
What can this be???????????
Hello people!!!!!! I am actually a VW and Opel screwdriver! Now I have a problem. My Mam has bought a Fiat Tempra combo. Such a great car Only now after two months lights up every now and then the lamp for the injection. It lights up a par second or a par minute but always goes out. Have already looked up the plugs and the mini spark plugs :-)). But don’t know where to look at the car :-(This is a model: Fiat Tempra Combo BJ: 2 5.9.1995 ccm:1581 Kw:66kw zu:4001 zu:686 Sorry, I haven’t got the engine code yet 🙂
-
Recommendation for exhaust system for TT with 180hp
Hi people want to buy me an exhaust system for my TT. Am I superior to which, maybe Eisenmann 1 pipe or 2 pipe. Does the 2 pipe system get the same amount out of both? MFG Daniel