Author: 00c12f

  • ATE Powerdisc hides too fast! Original??

    Hello, last year I bought powerdiscs and coverings at the eBight ATE in January (99,90 the set for the VA) and had it installed in the workshop. Jetz today I cleaned the discs after the screws with brake cleaner and already think that the aba arg look worn out. And then the mechanic, who was standing next to it, thinks that the discs also soon sin… at the latest with the brake pads, rather earlier.. Where I told him that the disc is just as long on it is wi e the coverings – 1 year – did not come out of the astonishment.. and I look more closely at the coverings as well.. The coverings are still almost as thick as new, but the disc is already so rubbed off that the groove can hardly be seen! Has someone experienced this beautiful? Has anyone any idea if you can see somewhere on a 1 year old Powerdisc, if it is really original? I have to know if I have to throw the thing around the dealer or ATE around the ears mfg kaindl

  • Audi 100 2.8 AAH switching suction tube Question

    Good day to everyone. I bought an Audi 100 2.8 AAH EZ:12.1991 with Tantarini LPG system last week. The following is what I have to do: The subject of the switch suction tube, I had an Audi 80 with AAH before and the switch suction tube turned off wonderfully. With the new switch it doesn’t at all. I looked at the cables and noticed the following The previous owner installed a cold running regulator and as it looks like he connected it wrong. Low pressure can from the SSR and from the throttle valve (small hole) a line goes to a T-piece and from there to the cold running regulator (bottom). And from the cold running regulator above a line goes to the engine block for the temperature sensing. Picture 1 I once drew THAT IS still FALSE So the SSR can’t switch. OR ??? I found the solenoid switch valve located below the LMM and there is also a cable connected blue and goes over to the????? I tried to unscrew the suction mount with the two 10 screws and tried to push it backwards to make it off but unfortunately I can’t. With my Audi 80 AAH it had enough bursts to the rear but with the Audi 100 I didn’t have a seat in the rear. I want to buy and connect new cables now. (what kind of a hose do I need?) Just how do I close it I found an ETKA picture and drew red and blue (picture 2) IS THAT RIGHT Do I have to pay attention to something else? Could it also be that the switching suction tube has somehow stuck because it certainly hasn’t switched for a few years. Should I somehow fix it or? As it is connected now it also pulls somehow wrong air that the car now has a bad idle it stutters in status. Thank you already in advance

  • Sport rear silencer for 500 SE

    I write here on behalf of a friend, who recently bought a 500 SE W126. has also changed some of the car, which is not my taste, because I find this car is the most beautiful original. he has dug out somewhere an old exhaust, which could fit for a golf. small pot two rrrriiiieeessßßßssiiiggggeee pipes. looks to the ko…, but he wants to have it on. problem is only the one has a small entrance (before the end pot). at the front I write here on behalf of a friend, who recently bought a 500 SE W126. 500 come but 2. he meant, which can be run together with an adapter piece in one. a friend meant that it would not be possible because he gets a backlog and then the engine would go on. so, now to my actual question. IS IT FOR THE W126 500SE OF A GOOD GOOD GOOD SPORTING DAMBER ??????

  • Gilera Runner SP or Peugeot Jet C-Tech ?

    Hello Community Did a decision question recently: injector or carburetor? Have I been informed in detail. Here in the forum as well as at dealers (some of them also had diagnostic devices ) My decision: carburetor The injector may run well and SHOULD have no problems but if what should be, “Workshop I come ” But let’s come to the actual question. What would you advise me to buy (price / performance IRRELEVANT)? What makes me intiress: performance, quality Rather the Gi lera Runner SP (http://www.de.gilera.com/_vti_g4_vers.asp?…) or rather the Peugeot Jet C-Tech ? (http://www.peugeot-scooter.de/) Please provide some reasons for your opinion (would be grateful for it). I will then drive my scooter open, (yes, in Switzerland it is legal ) I will drive it both on country roads and in the city (rather country roads) I will also do nothing, especially a couple of optical changes. (number plate, rear light, quite discreetly not) ts extreme.) To my person: I am 182cm tall and weigh about 75 kg.

  • Revitalization attempt Kawa KZ 750 E Year of construction 4/83

    Hello, I have here a KZ 750 E, grey import, year of construction 4/83, but not the UT, which dusts in my garage since 1997. Now I am thinking to put it back into operation, but there is still a lot to do. Unfortunately, however, my repair instructions have been lost over time. Can someone help me with you, since the book is actually no longer available, except for Amazon for 99,- €? Reperatures Focus: – Front shock absorbers, seals are through – Current speed lan, connection plan – Overtake and revive engine I might also need spare parts, such as side lid, gas handle, seat lock, cockpit. MfG, Michael

  • Commuter car 120 km a day

    Hello I am looking for a commuter car up to 6500 euros. My daily work path is altogether 100km highway (A31 and A30) and 20km highway. I drive an average of 130km/h on the highway. The car should have a relatively low fuel consumption at the speed. It should not have more than 125,000km down. Should have at least 4 seats. And be very reliable and not too expensive in insurance/taxes. It should last as long as possible and a Green and yellow environmental badge doesn’t need to have the car urgently. Maybe you can help me.

  • Torn from time to time – A3/Leon up to 15000 Euro

    Hello, I am looking for a new car. Currently I drive an Audi A3 8L Bj. 2001 1.6l petrol, in the year about 25.000km come together (commuters, 35km easy) – which is also the reason for a new car. Budget MAX. 15000 Euro. Originally I looked for an A3 Sportback Bj. from 2005, as diesel. What I still do. But they are quite high traded, e.g. one of BJ 2008 with acceptable equipment under 100000km you pay still good 12000 Euro. Now I was on the new car. Seat Leon attentively, there is as a new model with 1.6 TDI engine and good equipment with just 20000km for 17000 euros. E.g. http://ww3.autoscout24.de/classified/262941967?asrc=st i the mileage of about 25000km I don’t know now if the TDI still pays off. Maybe you can support me in my decision. Thanks already!!!

  • Mini or compact van for 4000€

    Hi, now I have to open a thread here. And indeed the Space Star of my grandparents broke today and now a replacement has to come. Actually they could just buy the same car again, but there are also other cars in this segment, I wanted to ask here for advice. Requirements are: -Climate -5 doors -Not under 90hp -level cargo space with folded rear seats (very important!) -approx. 18tkm a year -Nevertheless rather a petrol engine because of very many short distances not older than 10 or 11 years and best not over 125tkm on the watch manual transmission consumption not significantly above 8l/100Km -Excluded are already Hyundai Matrix (ugly) as well as my favorites Lancia MUSA and Fiat Idea (too small). That’s all I think, the budget is as mentioned about 4t€ ZIP code is actually unnecessary to enter here but further north than Göttingen/Leipzig/Dortmund should not be an ad if possible. I ask the question here in ers th line because of the foldable rear seats that have to give a flat surface and because 2 eyes don’t see as much as, well, more than 2 eyes What does this look like with Mazda Premazy or Ford C-Max? I’m also smart now, it has to go fast, my grandparents urgently need the car. MfG

  • Kymco Downtown 300i don’t start

    Good evening, I have a problem with my scooter I hope I find help here. Is an unusual mistake. I try to describe it. If I turn the spark plug out and do spark test, the spark is there! But if I turn a second spark plug back in and I generate compression then the spark is no longer there. If the candle is turned out the spark is there again. The engine turns a bit faster than with compression without the spark plug. ator? A bit more to the problem, 2-3 days before the starter ran about 6 km and got broken, replaced it already. The scooter is a Kymco downtown 300i / 2010 Thanks in advance….

  • Oil drain screw NMax125

    Does anyone know perhaps the length and slope of the oil drain screw from the Yamaha NMAX125? wanted to install a steel bus oil drain valve, but I’m not sure which size fits (for steel bus also not) thank you