For personal reasons, I have read quite a lot here about sawtooth and made an opinion about the best way to replace the tyres. To this I ask you to take a stand. My situation: just bought Golf IV, Conti Eco Contact summer tire, profile front 4.5 mm, profile rear 6.0 mm. I have just replaced the wheels front/back to achieve even wear. Now I have the vibrations and noise front, d When I examined the (current) front tyres, I noticed the saw tooth, on the outer sides of the tyres, which is responsible for the vibrations. So it was clear to me that this was not a good idea with the wheel change. Now I have collected the following information from the forum: 1. Saw tooth formation generally takes place on the non-drive axis. 2. From safety-relevant aspects should be on the r rear axle no worse tyres are mounted to maximize the life of the tyre set. Taking into account these aspects, I came up with the following idea, which will not be new, but did not appear here in the form of my knowledge. Here’s my suggestion (not direction-bound tyres!!): In the first alternating turn (e.g. after 10tkm) replace the wheels on the axles only left/right in order to compensate for the possible saw tooth. the sawtooth should be balanced. In the second alternating turn (after another 10tkm) the wheels at the front/back are replaced, the sides remain the same. I promise to wear the whole set of tires evenly and the sawtooth should not be large, since the tires have run equally much in both directions. That would not be “the classic” over cross, but divided into two turnsi. What do you think about this? If I were to work according to my model, ic h mount the “saw gears” from the front back to the rear, but on the side. Or on the contrary, I only switch left/right… if then the noise goes away? Let’s take this topic up again. I thank you for the answers in advance!
Author: 00c12f
-
Pirelli P Zero: What OE specification?
Hello together, would be the next tire for my Scirocco (3th Gen.) to choose the Pirelli P Zero in 235/35. At various online dealers I found this tire with the following specifications. Which would you order? XL K1 N2 XL ARR XL AR XL XL MC1 XL RO1 MO Legend: XL Extra Load MC1 Mc Laren K1 Ferrari/Maserati N2 Porsche ARR Alpha Romeo Racing AR Alpha Romeo L Lamborghini MO Mercedes RO1 Audi Quattro Thanks Stefan
-
Tire flat at tyre storage (tire dealers) Possibly rip off?
Today I had an appointment to change tyres (tire dealer/workshop) and I was told “when we got the wheels out was a mature flat and put a screw in it and “we recommend two tires otherwise the differential can break. All tires Run on flat 6mm profile. Has anyone here already experienced similar things? Is it possible to rip off some tire dealers to make more money?
-
How/ Where best to sell original rims?
Hello, I would like to change my ProCeed GTline to accessories rims and all-year tires in the fall of standard bikes with Michelin Primacy 4 summer tyres and would like to sell the original bikes. I have experience with eBay, eBay classifieds, but I don’t know if that reaches the possibly special clientele to Kia customers sufficiently. Also I don’t want to leave the lack of space lying around forever after the change. Did you have any other/better ideas as I could proceed?
-
Winter bikes
Hello municipality, my wife gets her newly ordered ProCeed GT in February. Now we need winter bikes and I wanted to ask if the wheels/tires from the front face lift fit. Because we got a private offer. The dimensions are 225/45/R17 91H on Kia rims. I put in a picture for you. I assume up to now that they have to fit and do not hope that the hole circle or similar has been changed Thank you for your effort!
-
Android Car Wired
Hello together, for weeks (feeling after the last update) Android car is as good as no longer usable: My mobile phone (now Xiaomi 12) loses the connection (if it exists at all). No matter which cable I use. Sometimes it works with the original charging cable. On the phone it is displayed then that Android car is connected, on the screen only “phone projection” is displayed (of which I don’t have a photo). When I tap it comes to that that I “certifate” a Does anyone have any idea what it might be about? Thomas
-
Xceed JBL Optimization
In my Xceed Platinum the JBL sound system is installed. It should not be about the sound in general here. In my case it is the case that I usually listen to music with a USB stick. Some songs and albums sound great, others not so great. Sometimes it is the case that from the trunk where the side speakers are installed a clear vibrating can be heard. I then have to reduce the bass significantly via the equalizer, that is annoying. If someone already has the disguise around the speakers the Is this complicated, or is it not possible for you to do so? Which material did you use and did it bring something to the sound? It’s not about the door speakers, but only in the trunk. I would be very grateful for information.
-
Tacho lighting with black light
Hello, since my interior (Golf 3) will soon be painted white – including the plastic part around the tacho discs – I have considered the following: I create a tacho disc in black, but the numbers are white. The tacho should then be illuminated with black light LEDs. I now have two questions: 1. Is there anything I have forgotten about my thinking, and is something like that allowed at all? 2. I would like to work something into the tacho disc with which I have the following E Achieving perfect results: During the day, the speedometer disc (except for the numbers of course) looks completely black; but if you set the lighting now in the evening, for example, a “Golf III” appears at a place on the speedometer disc, caused by the black light LEDs. I was thinking here of something like fluorescent color. Do you have an idea to realize something like that?
-
Search varnish that niemadn has 🙂
I’m looking for a two-colour paint that when you look at it is dark red and otherwise metallic black. I haven’t found anything like this yet. mfg v7
-
short question about NEON under the car
Sorry to start with it again, only everyone says something else. Ask for a short yes or no. Is it not allowed in principle neon under the car or would it be allowed zb: tube under the car with switch, so that I can turn it on and off in the car. and only turn it on while standing somewhere???