Author: 00c12f

Hello together, I read here often in the forum. Now I also write a post to my FZG: A Sprinter with protection case structure, 316 CDI 12/2013 – 128 Tkm. Yesterday the good me on the return ride unfortunately left in the desert. On the federal road at 70 km there was a jerk and nothing went on. No more gas, no proper steering, no real brake. In the display stood then Zig things. Among other things. Brake power distribution workshop look up. Esp unusual, ad blue lights also, mk l is now also on. End of song, had to go to the workshop. So far no info. Have read tens of things, but to the said error brake power distribution workshop I did not find anything. The engine doesn’t start anymore, instead it shows the tens of errors. Has someone had such a thing already? Or does one know? Had changed the battery a few days before and already made a few km with it. It is not empty or too low charged. I am grateful for every answer and tip. Greetings

Hello together and that I at my Sprinter since last October the brake lamp abs lamp track lamp and particle filter lamp on. After a recall action by Mercedes I had to bring the car there was built a new software and a new driver airbag since the lamps were wanted to wedge what could do for it. I then brought the car in a workshop there was cleaned the particle filter and as far as car has normal power and drives spwuer normal except the Mercedes wanted to install a new particle filter and the flex. Pipe was from that I had it welded again. The particle filter lamp was turned off and I should drive so on. Now the car goes into the workshop again in a week and will look completely. My question is I can drive another week so I always worry about carbon monoxide? Or what capput go also if I’ve been driving like this for 3-4 months and if there’s nothing that can be called kapput. But could carbon monoxide get into the car because the particulate filter can’t give an error message anymore?

Hello I have built in an ambience lighting and connected it via terminal15. How can I connect the lighting that it only goes out when you open the driver’s door and not immediately when you turn off the ignition. The radio stays on until you open the door. Of course, it would be best if the lighting already responds when the door opens like the interior lighting.

I changed the battery with my Sprinter first because it partly bad sprang up and it also sounded so slow starting, as if it weakens. With bridge no problem. 2 weeks after that also the Lima failed, not always, but again and again. Lima lamp in the cockpit and no charging voltage. Also this was changed and since then is quiet. But, the problem with the weakening starter persists. If you start e.g. several times in a row then the Anl If you take a vehicle to bridge then you can’t take only one battery to bridge then. After 1-2 hours it then starts again without help. I checked all the cables as far as possible, but can actually also exclude because battery is connected almost directly to the engine. I would now like to expand the starter to check the contacts and/or to replace the starter. Can someone tell me how I rec Is it easy to get the starter? It is the normal 4 cylinder 2.2 CDI

Help !!! have a Sprinter 315 CDI – Bj 2007 Motor OM 646986 in October I have New AT engine – and New AT gearbox Built-in since about 10,000 without problems.. Last week I had to step on the highway at 120km suddenly on the brake, because in the last second one still had to push in front of me.. had two big dogs in the Sprinter !! one banged at the brake against the automatic lever from (D) – on (P) then noticed that after the brake.. Possibility to take everything to the right in P, only slightly clacked. after which I had overcome the shock.. Motor-made short break, then everything tried D – R – P everything went then continued driving about 250km later, then I heard a loop / flapping which became louder and louder when giving gas. then drove off the highway, then MKL to motor went off… Then it didn’t start anymore.. ADAC towed me, Sprinter has now been brought to a friend in the workshop. .. Engine Turns Without Compression !!! Question : Gearbox is dead !!! but what could have happened with the engine .. ???? Starter Turns but it sounds quite easy, has motor turned on flywheel with ratchet goes very light and comes only short at a point where it is difficult !! has no compression !!! knows no more now… will next week motor and gearbox supports !! have no explanation why the transmission damage, also the engine can have a damage?? a statement reports to you Thank you in advance