MOTOR-TALK

Author: 00c12f

  • Screws motor holder right 1.4TSI CZEA

    Good morning together. Can someone write me the part number of the correct screws for the right engine bearing? Would it like to swap and since these are all stretching screws, they must be new… And if someone knows the right tightening moment, I would also be very grateful

  • Error message Emergency or Travel assist

    The constant beeping as well as the error message for the error or non-function of the Emergency and the Travel assistant is really annoying. The problem exists for about 2 to 3 weeks, was several times in the washing line to exclude contamination of the sensor/signalling devices.

  • After cooler exchange engine temperature fluctuates and heating only works on “High?

    Servus together!I own a Seat Leon 1P with the 1.8TSI from 07/2009.Today I changed the cooler, because it was leaking and had dripped. I ventilated as follows: Run the engine warm, heat on the highest level and with warm engine then the hoses slightly pressed together until the coolant has remained constant and no air bubbles have survived. Now I have the problem, however, that if I drive with the car and the heater on the highest level If I set the heating to a normal temperature of 22 degrees, it goes back to 90 degrees. In addition, the heating of “LO-26 degrees” does not heat (feeling cool air comes out) and only as soon as it stands on high does the extremely warm air come out. Do you know this problem?If air in the system, then it wouldn’t heat extremely on HIGH, would it?

  • bmw 650xi when the woman puts her hand on 🙁

    Good morning to everyone , Have a little problem or my wife has put hand on my 650xi. Saturday I was working on and my wife took my 650xi because she wanted to go to the city ,then came the message cooling water please refill blah. She called me and because I had no time ,I told her that she should pay attention to the on top of it that you should be careful because of internal combustion engine danger etc if she can find the lid she Wass he pour in .naja my mistake because the 650xi has yes two of them, once the main balance tank centered at the front of the engine and once on the driver side at the back. My wife filled it naturally at the far back where not even a min. Max. marking is .. my question: what is the one on the driver side? And is that bad if you have filled in 500-800ml water? By the way, the message did not come to him anymore.. I guess because the 650 yes water cooled turbo or charge airk ühler has, there are two salaries for cooling water , but they would have to hang in the same cycle or ? Would be great if someone had an answer to the questions since I unfortunately did not find anything on the net .. nice day to all of you and enjoy the sun my dear ..

  • Set cruise control 30 km/h

    If I want to turn it on at 30 km/h, the message “Speed is not enough”. If I want to set the speed at 30 km/h, the speed is not enough.

  • Exchange coolant temperature sensor

    Good evening. Would like to replace coolant temperature sensor with my vehicle knows someone where the sitting I did not find it. Peugeot 407 Bj2008. Thank you very much

  • Juhuuuuu!!!!! My RRE is here!!!!!

    So dear Swiss, from now on always nice all white Evoques greet (mainly in the Zurich Oberland), I could sit inside I am so happy, ride home was nice through the snow, he did well the little one Now he stands in the underground garage and waits for tomorrow, I think I can not sleep tonight and must go visit him once in the Pyjama Many thanks here also to the nice people at EF in Z, until now the car still runs P.S. : If someone asks, the mounted The rims are OZ Versilia 18″, which for the summer are then the Style 5 19″. I think the OZ are doing quite well at the car, could not imagine that before that so exactly.

  • RRE brings error message and just stops

    Hello, I just drove a lap with my RRE Diesel – suddenly comes a warning message – he just stops on a slope – warning message was with a triangle – could not read you exactly, so scared was I – tried to start again – did not manage – the temperature was so around the – 10 degrees Celsius – that hopefully can not be the reason. After a few seconds I made another start attempt then he finally started again. 700 M eter continued the same game once again – warning message with triangle (something with power drop) and stopped again. Restart – he jumped again. After that I drove about 4 km and there is no error message and he no longer dies. However, it always lights up the warning light “motor malfunction (GELB)” – which means that there should be an error on the engine. One should attract a qualified help. I called the LR Euopa service. Lady said the yellow message said that you can continue driving but should go to a workshop as soon as possible. I will probably have to do that tomorrow Monday, today there is no workshop open. If someone of you has an idea what this could be – I am totally worried and upset. There you have such a great vehicle and stands at once !!! Please for information – Thanks.

  • Expand secondary air pump and solder resistance?

    Well the stupid part is broken with me and now I finally want to eliminate the error. But I will certainly not spend 500-600 euros for the nonsense. I will simply expand the part and wanted to ask if it would be enough instead of the pump to switch the fuse between? If so how big should this be? I have something of 2-3ohm??? Does someone ever have a photo on which man recognizes where the pump is sitting!? I don’t have to expand the part, just pull the plug off and the Wi or can I also install the resistor in the engine compartment in the fuse box? Greetings

  • Toyota Proace engines from Toyota or PSA?

    Good day Come the ProACE engines directly from Toyota or are the engines of PSA=franzosen-Diesel ? The dealer thinks the engines come from Morocco, wg. Dacia He has a bird or it was an April joke ? the other dealer also has no idea – What kind of gestures mfg