Hello dear, Hyundai friends, Is there anyone among you who likes to drive a XI55 and possibly also screws myself? Since mid-January I have bought this part and am very satisfied so far. Although it is from ’09, when buying (from the Hyundai dealer) had only 65tsd. On the watch. My plan was and is still to pull 3.5 to. For this I wanted to have it chip-optimized to get more torque because it seemed “underside out” very slippery. Until about 1000-2500 U/min didn’t happen much, but from 2500-3000U/min it goes really well forward, despite its almost 2.4 to empty weight. Actually rather untypical for a 3.0L turbo diesel. As the performance measurement then showed (unfortunately no roller dynamometer) the Fzg has neither before nor after the optimization nor even the factory specified power nor torque. Shit. 400€ in the wind and the old software played on it again. Nevertheless, he needs 1.5-2 liters more than before r. Has anyone had similar experiences? And/or even a solution? The tuner said that there had to be something wrong with the engine (oh no). With a turbo speci – Turbo in order but the exhaust temperature probe before Kat is not in the right place. It delivers a constant value of 28 degrees C. For lean 256€ at Hyundai a new order and built in – no change. And Nu?
Author: 00c12f
-
Wet windshield
Hello, do you also have the problem that your windshield is often really wet from the inside this time of year? Looking forward to the winter again if I can scratch from the inside. I don’t carry moisture into the car…..Interior filter is new and climate is always running. It’s about a Santa Fe BJ. 2013
-
Mazda 6 purchase advice
Hello, Would you like to buy an economical diesel with acceptable performance. That’s why the Mazda6 with 136/143 hp come into question. All under 125,000km; good equipment (Xenon, cruise control, partial loader, Navi, etc.) -> These are the ones I found or are interested in. My questions: Are these good engines for frequent drivers? What is the response? Do you feel the 136/143 hp too or are the engines rather sluggish? Are there general weak points with Mazda6 2.0 diesel engines or at the car se Thank you, Philipp.
-
Fuel consumption
Hello.Have crossland x with 1.2 ltr. and 110 hp automatic.Bj. 6/18 with Euro 6 standard and still consume 10 ltr/100 km despite current software.Has someone similar problems and can give me a tip.Thank you.
-
Experience with lowering?
Hello, my Freudin has recently moved from an Astra GTC to the Crossland X. She wanted a higher car. Due to construction, the Crossland on the highway is of course different to a sporty GTC with a low focus. However, he is a bit too spongy for her and therefore I wanted to ask in the round if who has had similar experiences and missed his Crossland e.g. 30mm springs. How has the driving behavior changed thereby?
-
Delivery Stop
About 3 weeks ago, my Opel dealer informed me that Opel has ordered a delivery stop for the Opel Crossland X. 4 weeks ago, I signed a purchase contract for an Opel Crossland X with an Opel dealer of the Brass Group via an Opel Crossland X, which is in stock but can not be delivered now due to alleged improper welding points on the back bench, exactly could not be explained to me and even a demand at Opel in Rüsselsh im was unsuccessful. It is certain that about 400 Opel, which were delivered to the dealers, are affected by this. Opel now has to check how the problem can be solved (and now for more than 2 weeks!). I find the whole thing very ridiculous and doubt now whether it is really only problems with the back bench. Does anyone possibly have more insider knowledge??
-
Brake fluid level Error code B1032
Hello, with my Ford Ka(RU) Bj 2009 comes the error message: Stand brake fl. Insufficient. Do not drive any further. When reading is exactly the same with the error code B1032. But there is nothing to find about it. Brake fluid level is with Max and the brakes are also in the right place cable are all ok. I thought that the sensor is defective on the brake fluid tank, but did not find a sensor what you can buy. Have you had similar experiences or other solutionsvo Thank you for your answers. LG
-
Philips Ultinon Pro6000 Boost H7-LED
Hello forum community, could I theoretically replace my existing H7 luminaires with the Philips Ultinon Pro6000 Boost H7 LED? Or do I need an adapter to connect to the factory-side connector? Thank you in advance.
-
Mazda 6 2.0 (GH) Purchase?
Hello all, I have an offer available over a Mazda 6 MZR GH 2.0 liter Exclusiv – Bose + Touringpaket. EZ: 01/2008 – For 19,000 Euro + set of winter tyres and 2 years warranty extension. Was a demonstration car and now has 17 tkm down. The car says very well to me.. During the test drive no defects occurred to me. Does (actually) class. What do you think about it? Are you driving because it was a demonstration car? Greetings & thanks