Hello, I had to go to the Tüv and the one at the front to the right of the carrying joint. So I drove to a Free Workshop and gave them the order to change the joint. They did so too. Only in what way! The old joint was fastened with rivets to the cross-leker, so that the work first had to drill the rivets. Then the locksmith took a hammer and Meisel and removed the drilled rivets with it. Only he hit the axle to which the carrying joint was still attached. After 30 minutes!!), I wanted to go home and realized that it was a terrible blow when it was speeding up.And the track is also totally distorted. So I drove back to the factory. and they didn’t think that they had done everything right.And you didn’t have to stop the track, because they wouldn’t have done anything about it! If I was going into a left-over or the clutch, that’s it and the Cali runs quite quietly. I then drove to the foh, and she said: Then, that when the joint was disassembled, the drive shaft was probably damaged or pulled something out of the gearbox when riveting with the hammer. He would have had to release the drive shaft a little bit, or the carrying joint first from the axle. And the track would have to be adjusted, because something was changed on the chassis.And especially since my Cali was even deeper he would have had to install the carrying joint under prestress! So I drove again to this Pfu… workshop and wanted to clarify this. But no chance. They didn’t even try it to convince themselves that something beats. Now I turn on a lawyer after a huge fight. An expert commissioned him to look at the matter! The workshop now wrote to my lawyer that the car had even more defects. The brake lines would be a little rusty and he wanted to let me shut the car down by the expert. He couldn’t understand how I got it over the door. rage: Can this expert shut me down??
Author: 00c12f
-
Ebay and the Good Manhood 😉
Just looked at an auction saved at the time. I had set up my faithful B4 for the time being, after always some broken German-speaking entrants had at some point not registered after futile haggling. Understoodly, I wanted to point out in a note text at the end of the article description the usual rules. The auction was then solved by Ebay with the reference to “racist statements” After the sale! So the correct (by the way also German) buyer could no longer positively rate. On my further demand with the moral guards of Ebay I got no answer. Here times my note text (which can be used with copyright notice 😉 ):Requests for a sale outside of Ebay during the current auction, as well as offers á la “How is last price?” or “can you let car registered” remain usually just as unanswered Ebayler, who in the past received a negative rating as a “fun bidder” or because of obvious frauds… are excluded from this auction. Likewise Eastern, Southeast Europeans and non-Europeans, who do not live in Germany for at least 15 years….LEGAL in Germany! Colorful business cards I had so far enough to stick to the car. If I would have wanted the car for 2 0,- Euro goes to Yugoslavia, then I could have had it for a long time. And that was a long time before Sarrazin ;-).
-
16V ACE with ABK Digifant –vote–
So. Continued in the program. I talked yesterday with aggregator5 bits since he already had an ACE 16v run with an ABB Digifant. He meant the ran brutally bad and did not adjust himself better. Lief probably much too lean despite petrol pressure control etc. He then took the control from the ADA 1.8 20v and this worked wonderfully. Now my question. Is there a possibility to adapt the field of the Digifant directly to the ACE? What do you need? t here someone such a thingens and can explain this to me or help me directly? Has this ever been done by someone else? So ABK Digifant on ACE and it worked wonderfully?
-
B4: Temperature indication indicates too little
Hello dear target group, where can I still look to get my cooling water temperature displayed correctly? – Voltage regulator is tested / replaced, tank indicator is correct – Multifuzzy is new – Tank display istrument replaced – AI board soldered, sucked, everything doesn’t help. – Mass connection tested at Multifuzzy, is there still any plug connection between Muktufuzzy plug and AI plug that could be gammelig?
-
Windshield
Servus Audi-Gemeinde. I ordered a new windshield from Audi… I got a green wedge on the built-in windshield. Since I didn’t know if the windshield was tinted, kept a sheet of paper behind the windshield and noticed no difference…. I assumed that the windshield was white, so it was untoned… Yesterday, when the windshield was picked up, the new one seemed very bright to me… and at the bottom right of the windshield that is installed, vsg tinted… on the new one isn’t… h Does the “tinted” that the disc is tinted?? about the chassis number can unfortunately no longer be found out, whether the car has a tinted disc or not…. in the original catalog it says that the Audi 90 has green color glazing as standard…. Does this only apply to the side windows or also to the windscreen??? can someone help me? Thank you…
-
Tips for buying quad
ch am absolutely Quad enthusiastic, now I would like to buy one of these things for the famolie!! To me, I am 21 years old still go to school, earn about 250-500€ per month Now I am looking for the right vehicle for me.The following conditions should be met: 1)land suitable 2)2 person approval 3)A bit of power would not be bad either… since I might also want to take it to the mountains For suggestions, which quad would be recommended, I would be grateful. For type, what I consider when buying of course should!
-
MX5 NB Change the top, which manufacturer and what needs to be considered
Hello, my NB still has his first hat and after 22 years he should get a new one. It is important to me with the new cover that the quality is right and it looks nice. I have set for me the following points: 1. fabric cover, because: In my opinion looks better and moreover it is not as stiff as a vinyl cover at low temperatures. The greater stain sensitivity does not bother me (garage). 2. heatable glass disc: Have the experience that the I would like to see through the window something that is limited to the determination of whether it is bright or dark outside after a short time. 3. Rain channels above the door windows worked out so that the water does not drip into the seat when the door opens. As a brand, I have taken Sonnenland into account. Has anyone had any experience with it? Are there more well-known manufacturers, which you can recommend? Would you do the change yourself? I am in Hamburg, does any of you know a good contact person for this? I look forward to your suggestions & discussion Greeting
-
Sprinter L2H2 163hp or 170hp?
Moin, we were at Mercedes today and have looked at some sprinters and have already selected 2-3 models. Now comes an exciting question 163 or 170 hp, i.e. OM651 or 654, which is the more durable engine? Both have the same torque, I would rather type the 2.2l instead of the 2l engine, but I think the 651ers have some diseases with water in the charging air cooler, at least the woman has the problem with the CLA X117 with 220cdi, which should be the same engine. in anticipation of your opinions, price up to 40,000 euros are both engines in it, so could choose the better one. Lg
-
AdBlue display can no longer be deactivated, vehicle no longer usable
Since the end of 2021 we drive the Mercedes as a leasing vehicle. In November the Adblu advertisement went on for the first time : Störung Adblu 800 km remaining time, only moch 2000 tours possible We are to the workshop, which have read out the error, we could continue driving. Almost 3 weeks later, same problem, again to the workshop, this time a valve was replaced. 2 weeks later, same error message…. Stand by, error disappears 3 weeks later everything started from the beginning. Störung Adblu 800 km remaining time, however, the engine now also ran in higher tours. In the workshop you are now completely perplexed…Neither the headquarters in Stuttgard och the colleagues here on site have a plan. Has anyone heard this before? What do you advise ?
-
Set off the preheater
Moin, Mein alten Sprinter (BJ 2005 ) has for some time the problem, which slightly in the parked condition the battery sucks empty. The radio is meanwhile expanded – now we have the preheating in suspicion, which just recently turns on unmotivated. Permanently when parking the negative pole of the battery is also not a solution. There is due to the age no proof of use for this car. How do I adjust the preheating reasonably? How do I find the error i n the electrics? I am a DAU (the stupidest user to accept), but the whole screwdrivers also did not know any advice…. I hope for an answer ; thank you in advance