Category: Fahrzeugtechnik Forum

  • Brake ceramic paste, plastic cube, special grease what kind?

    Hello, short question: I usually use for the brake cleat ceramic paste, is the plastic cube better suitable for this? For example the guide bolt, what is taken for “special grease”? Normal graphite grease? or also this plastic cube? Thank you.

  • Engine oil analysis in the laboratory at oilcheck.de (experience / sense)?

    According to Service Heft, my current car (VW Polo 1.2 TSI 90PS manual switch) had a long life oil change service about 20 months ago and 20,000 km ago. This was done at the “big” 60,000 service inspection/interval. According to the display in the Tacho, the service interval including oil change is soon necessary. Both in time and from the kilometers this would be completely fine. However, as I will be driving less than 10,000 km per year in the near future, I am superior to normal oil and Before that, however, I would be interested in how the current oil is. Especially because I have driven relatively many short distances in the cold months. At oilcheck.de, an analysis set costs 61.50 euros. Do you think that it could be worth it or is it rather completely thrown out money because the oil is so and so completely through?

  • Contributions to professional cooperatives?

    Hello people, My cousin wants to establish a secondary trade in order to be legally able to carry out repairs to motor vehicles for a fee. My question is now, is he not obliged to hire employees BG? Does he have to comply with the same regulations as also large workshops with several employees like e.g. UVV equipment testing etc. How is this if I am employed on occasion on 450€ basis, then what changes? Hope you can help me MfG

  • Car takes longer for ignition after short standing – what could be the cause?

    Moin! Watch the following phenomenon for a while already with my Mazda: The engine starts after a long time stand normal. But if I park briefly, buy and start again (so let’s say 5 to 20 minutes of service life), then the ignition takes considerably longer. One then hears this whining (does it have a better word for it?). Ask me for a long time what could be the reason for this. Someone an idea? Recently changed battery and spark plugs. . Thank you and greeting

  • How do I know with how much power / Nm I have to put on my spark plugs?

    Moin! Can someone tell me how I know with how much force these spark plugs have to be tightened?https://www.kfzteile24.de/article details?… male thread: 14.0 mm spark position: 3.5 mm thread length: 17.5 mm key width: 16 mm spark plug: fixed SAE connection spark plug: iridium medium electrode spark plug: 1-mass electrode spark plug: destroyed, 5 kOhm spark plug: with cone seal seat Thanks and greeting

  • Consumption by slope and gradient

    Hello municipality, I have a question about fuel consumption: Suppose I drive exactly 10 KM with exactly 100 KM/h a 5 percent gradient up and then exactly 10 KM with exactly 100 KM/h a 5 percent gradient down. Is the consumption equal / higher or lower than if I drive exactly 20 KM with exactly 100 KM/h on absolutely flat road?

  • Battery Charging via external battery

    Is it possible with a full 100amp battery to charge a built-in battery with a voltage converter and the cteck 5.0

  • Brake tight – why?

    Hello, today the Skoda fell through at the HU, wheel at the front left not freely accessible. This is now the 3rd car, where a brake is stuck. Do I brake wrong or do I drive too little? The driving profile was different for all three cars. Can you check that somehow or notice it while driving? Sure, you can of course regularly pick up the car and turn the wheels… Or feel the temperature of the wheels after driving, now the warmth of the affected wheel radiates strongly outwards. can also be used regularly with brake cleaners, I read during the googling, that it can also come from dirt from the outside to the fixed seat of the brake. Well, unfortunately I only got the workshop appointment Friday… Greeting Rob

  • 2000 Watt converter does not create coffee maker with 700 Watt

    Have a new power converter 24 volt input and 230 volts with 2000 watts continuous output. What can it be that of a coffee machine with 700 watts not. Have also let the engine run. Have also tried a halogen light emitter with 500 watts,the same problem

  • Which light source are you using?

    Hi people. With my Golf 6 the light bulb has burned. Now I think about which brand I should buy it. To choose from: Bosch Gigalight, Philips Longlife Ecovision and Osram Nightbreaker. Since I have not found a current thread I open a new thread here to read your reviews with the respective light sources.