Category: Car Audio & Navigation Forum

ACR recommends: Axton Soundboard CAX65 (thanks to headrests in the back, it couldn’t be a bullet in the event of an accident) The Axton C502 and the front compo 2.18 (16cm) and a powercap (ka which). D&W recommends: Rockford 301X Rockford 12″ Woofer with housing MB Quart DSE 216 Both offers are included cables, but without insulation. Both want to be used for the goods have 700€. I put mainly value on good sound. The volume should also be correct, however, not too crass. (No drag, but everyday life) The Woofer offered by D&W just fits into my room presentation, it should not be bigger. What is the better choice now? Already thanks in advance for your help ! edit: The car is a VW Golf III and I would also have 2 3-way boxes (Sony) that were otherwise in my hat storage. (eventually as Rearfill ?)

Is there any way you can read from the graph in WinISD whether it will roar or how the sub will play about? How does the roar actually come about because that’s the last thing I want.

Heho as the headline already says. I would like to know how it is with a 2nd battery in the car. since a 2nd battery is not the cheapest I wanted to hear the difference first. If it doesn’t bring so much I can also hang an elko on it. So I thought that I just turn a 2nd car with starter cable on my clamp both motors on and then look what more is going on because my battery with the 310 is a bit overridden 🙂 en trenrailes came up and I wanted to know if it doesn’t matter if I close it for half an hour or if I can get problems there… thank you already :als -booby-

Hello first of all! So I have a problem with the basses. There is absolutely no pressure and as soon as I make a little louder the basses completely oversteer and it sounds as if they are full throttle, that’s right. The problem is with my rear speakers and with my subwoofer. I already have all possible settings on the radio and at the power levels tried but the problem is always the same. Below I list my components: Radio: Panasonic CQ-D FX572N (Mp3,CD,…) Output voltage 2.5V 6channel Front: 2 x Infinity reference 452i 105W Rear 2x Inifinity kappa 693.5i 330W to Magnat Bull Power 6000 Enstage with 600W Input voltage: 1-10V Subwoofer: Pioneer TS-W383F (Free air subwoofer with 600W, 38cm) to Magnat Bull Power 6000 Power amplifier with 600W (only 300W are connected to subwoofers because only 1 channel is connected) Power amplifier from the subwoofer is connected to the subwoofer out from the radio. The parts are all new purchased and were also nick grad bill ig, so I’m sure it won’t be the quality. I hope someone can help me here, thank you!

MOIN! OK, I drive an E220 Coupé (w124, Bj 11/94) and want to optimize the sound! For me it is not possible to mount a bass roller or to perform holes etc.. But amplifier installation is OK… Here’s the question: What can I do to optimize the sound (exchange speakers…). Is there one or the other tip? Recommendations for purchase? I am grateful for all suggestions! Bye, the Hamburger PS: Money plays a role but only the second one!

I have spent hours to connect my new battery. The following problem: The components are the same as before. Only that they are now fed by the additional battery (instead of the starter battery) [Trennrelais]. It is now a “Plöpp” (so a turn-on impus) over the speakers. From the subwoofer it is hard to hear and see. (Monoblock) But it comes from the front system as well. (4-channel) The “Plopp” not only works when switching on, I’m surprised when you turn the volume from “nothing” to “it comes music” on the radio. What can this be all about? I’ve also tried to feed only one amplifier with the music signal (chinch) (Y adapter away).

Good day for the first time ! First of all thanks, for the tips how to get the door panel off and then the boxes. I bought from Alpine a system for my Passat 3BG, Alpine SXE-1750S > Front doors 2 – Ways Speaker Kombo System 2 x 280 Watt Max / 2 x 45 Watt RMS 165mm Diameter ( Bass ) 30mm Diameter ( tweeter ) Capacitor / Elko on tweeter 60 – 20,000 Hz 90 db 4 Ohm Alpine SXE-1725S > Rear doors / Sides Rear 2 – Ways Coaxial Sys tem 2 x 220 Watt Max / 2 x 40 Watt RMS 165mm Diameter 47mm Installation depth 60 – 20,000 Hz 92 db 4 Ohm My problem now is this, I built and connected the rear boxes, they also work, but don’t have the sound I imagine. I had a 2-way combo system in it before and have now connected the 2-way coaxial system! Can someone help me further ?

Hello, have a Bmw E36Coupe, have bought me the Hifonics ZX 12 mittelwile I have it so far that there is also in the vehicle inside a really good bass, but it is too big for me he needs almost the complete trunk! Would you like to buy me now something new doesn’t have to have as much power as the Hifonics, but should have a possible small egg tife so that I still have a lot of my trunk, what do you suggest??

Hi, everybody! I’m just planning my trunk expansion! And again comes the question: “What’s coming in”? I usually hear HipHop, Black and Co. but it can happen that something else is going on! Luggage compartment is rather small (golf class or even a little smaller) And now the question – what would you recommend? 2 * 10″? 1 * 12″? 2 * 12″ would probably be too much space And also the 10″ and 12″ would I rather be in a closed housing. If so, which of the upper possibilities? d as I said – I want a closed housing – even if BR would be more for my direction. but the place – the place! Hope you can help me MfG nullchecker

Good day. Does one know the MA Audio Bass with 10000Maxmaller power and 5000sinus? Is that good?