Category: Car Audio & Navigation Forum

  • Upgrade golf4 mfd speakers

    Hi people, was first in the wrong forum…: There are already some threads to the basic topic here, but I’m looking for some more special experience with upgrading a golf 4 based on the navi-mfd (built in 2003, scissor speaker front and rear, no bose system) I want to sacrifice the trunk for a bass box, probably double bass reflex or double closed, in combination with digital power amplifier so 500-800 rms, 2 fiberd condensator, 50 mm2 cables from the battery now my problem is to design the front pair of speakers in this way (behind a few are left out, will be overdone anyway), that with minimal cable installation effort a listening experience is created that resists the bass pressure! Does anyone have experience with a similar set-up from the bass? as far as I know, the standard speakers are driven with the Navi integrated, low-browsing end stages (which is why where Hl the sciss navi cds always so hot). my main question is now how thick and how loadable are the already installed cables and there are any end stages that can process the already reinforced signal of the Navi as input, but at the same time offer the possibility to pass the new output power to the already existing cables ? How is all this done with the Bose sound system ? my dream would be if I could just switch between such a Bose end stage and d then only the loudspeakers (in the door and in the A-pillar) would have to replace. maybe I will also dam the doors, let’s see.

  • shelter byebye action!!!!!

    Hi is a well-known driving teacher and there e often sends people to me who want to put “boxenteller” on the shelf. now I suggested what to hang up with him and he was immediately thrilled! so I need pictures and pictures. of bad installations and accidents like this. writing etc. I can do this myself – tips nevertheless desired. this is a very great driving school so many people will see that too…….if it brings only 20 people the insight it would be great but i ch think that will be many more. this forum I will also “link” here there is simply the least spinner. and friendly tips without “haha du depp”. otherwise no direct advertising on it. only bitle what about :http://en.wikibooks.org/wiki/Car_HiFihttp://www.autohifi-magazin.de/d/48302#http://www.profihifi.de/sites/wooferkisten.htm and keep my tel. number for free advice. thank you for the help! byebye

  • Which one of these radios?

    Hi, which of these radios is best in your opinion? I am especially important that it has min. 2 VVA and the sound is good, MP3 and a good radio reception. Please don’t suggest any others but just go into them here: 1. PANASONIC CQ-C5301N Would be my favorite because I like the design and it has a motorized flipdown which I like very much. 2. JVC KD-G511 has color display, I also like it quite a bit. 3. KENWOOD KDC-W5031 I would already have the distance-bedie ung (my old is also a Kenwood (KDC-M xxxx) and I was actually very satisfied with it, unfortunately it starts to cause problems now and has just one VVA.) Here I also like the design and I had a Kenwood before. 4. Bluepoint Calgary MP35 Shall have proper sound. Design I don’t like so and quite limited functionality I also had a CLARION DB-358RMP in mind, but 2 VVA are mandatory, so it falls away already. Tjo would be nice if you would tell me which of these is the best, I would like to have the first one because of the functionality. But the sound and reception must of course also be correct and is more important. Front system is a Hertz DCX 130 which will soon be operated by a Blaupunkt GTA 200 Flash. Subwoofer will probably soon also be a Hertz, operated by a Carpower. mfg

  • New Radio due: Experiences with mp3-skip times???

    New radio due: Experiences with mp3-skip times 9812RB ??? Hi guys, my good old Sony gives up my mind so slowly, because it jumps constantly, especially with burnt CDs. Since I needed a reason to buy a new one for a long time…warm now at the time I play above all with the thought of buying an Alpine, Clarion, or Pioneer, because from Sony there is no one with LZK, or ? Have seen the 9812RB for 275 at guenstiger. I find for the price really super a But I don’t know where to test it. And that’s where you get into the game Who can tell me how the radio behaves in mp3 mode? (Please without pink-red glasses) – How is the Skip time? – Will the title be displayed immediately on the Skip to the next song, or only when the playback starts? – How long does the radio take to read a CD / change folders? – How is the basic noise in mp3 mode when quiet? Thanks already to all

  • 100W RMS at 1% klinr ! how much W rms at 10% klinr?

    hope that we can install this thread a little more theoretically than the “to the amp. knowr”, since we have all doubted my honesty related to my 140 DB. the original question was if I draw more power from an amp, if I step up the gain and additionally turn up the bassboost fully. so …… the gain is as we all know, not the “lutstaerken controller but the regulator that regulates the input voltage sensitivity and the bass b. d. he, who raises a sound pressure increase at a certain freq. mostly 40-55 Hz by 3,6,9…18 Db. so if I turn the gain controller so high that it is more likely to distort it it does mean that she plays in the clipping or? but that also means that if I play even further on the gain controller I have an even greater distortion and that again an even higher performance or? because the performance specification RMS is always coupled to the clir factor 1% or thus man the amps below which can compare or ? so if my or share of my contribution is wrong I ask to explain it factually, since we all learn nothing and it is little produckive.

  • Is it aluminum instead of copper or am I wrong?

    Who can help me with that I drilled a new hole at the we at a mass distributor, and actually thought to me that the one is made of copper. Now after that the great gold plating was gone only aluminum came to light. Is that normal that the parts are made of aluminium and not of copper? If I could easily take an aluminium block and make myself a distributor. Or is there any use of you. Somehow now I don’t see any more through I always thought copper is the better ladder why was the part made of aluminum? The distributor block I used is from Sinus Live Who can help me now what I should do, make one of copper or one of aluminum? I will not buy any more that a buddy can make me the

  • MTX Jackhammer, opinions?

    I’ve finally found this thing!http://www.mtxaudio.com/caraudio/products/subwoofers/jackHammer.cfm I think it’s really cool, what do you think about it? I know that it’s a shit tax with 7499$, but: it’s worth it? I don’t know about systems soo well, to install a small one with 400 watts my knowledge is enough, but with the Jackhammer sets out! What does everything have to do with it? How many additional batteries? I find this is the hardest thing I’ve ever seen….

  • Experience with SPL Dynamics

    Hi Leutz Bin etz just before I get 2 SPL Dynamics Pro12D4 and that’s why I want to hear a few comments about this Woofer. Do you already have experience with SPL Dynamics? Would you like a high level Woofer as I want to participate in EMMA ESPL in a fun way. What alternatives could you call me in this price segment (about 300€ per Woofer). Music direction is 80% Black. Thanks in front of the guys.

  • Additional battery broken now a new one just what kind of one?

    I used to install a normal battery as an additional battery in the case room all the time. Only she blessed us with the time. Now my question what should I do for one? I would like to charge my second battery with the Lima like before the old one can I install a gel battery without further effort? or what do I have to consider then separation relay is so everything in it just wants to replace my additional battery and install it even better in the same train and should be And ne gel doesn’t necessarily have to be me would be a simple solution without a problem, preferably so that I can throw it back into the trunk and just plug it in.

  • xetec woofer

    new car new woofer ???.. ESX V 840.4 ? sevus bought me a Xetec (x 12 s) a few months ago and I am very satisfied with it. now I drive an Audi A4 B5 and the trunk is quite closed at the audio ! A bit of Musi gets through already, but not very much !! I thought maybe I would buy another xetec woofer and then it would have to run better. My XI amplifier does 2 x 200 wrms and that will then be possible. or I will sell this completely. e, what I don’t want, and buy something with more bangs (dd, spl) or I flap the back seats down !!!! please help !!!! ps: ESX V 840.4 someone knows this stage ??? mfg andre