I would have asked a few questions about my car radio. – Corsa B – Built.: 04/1997 1.) I have now installed a radio (don’t know which (brand: blue point) I can only turn on myself. Actually, I know this so that if I turn on the ignition, that the radio also concerns. But I always have to turn on and off my radio manually and that’s annoying. Which connection do I have to change?? (Please as uncomplicated as possible, because I’m not as experienced in it) 2.) I now have a new one. it bought radio from JVC KD-R301. I would like to connect this also tomorrow but my JVC has only 2 plugs but my blue point 3 plug. Do I have to change some cables now? I already tried to install the JVC today but it didn’t work. When I connected 1 plug, it went on briefly for 1sec afterwards but it went off again.
Category: Car Audio & Navigation Forum
-
Purchase advice Final stage / Subwoofer
Hello, I want to “build up” the sound or mainly the bass in the car. I want to “fit up” a subwoofer or a hifi box into the car. I need a power amplifier for this.. However, I don’t want to spend more than 80 euros for the power amplifier. (I know it’s little but I’m currently short of money –> holiday ) Today I was in the media market and this power amplifier was recommended to me : http://www.amazon.de/Renegade-REN1100S/dp/B000UL2Q2Y The data from the HiFi box, which I’m looking for my car radio : http://www.testsieger.de/produkt/alpine-cde-126bt.html My question now : What do you think of this “set” or the final stage? What additional subwoofer would you recommend to me? Thank you in advance for the answers!!
-
Help: THIS power amplifier on the car radio possible? Your opinion asked.
Hello! My new car radio has 4×45 watts. At the front of the car are 10cm magnat (middle and woofer) and at the back almost 18cm magnat boxes (middle and woofer) installed. the boxes were already in the car. All boxes directly connected to the radio: I lack a bass sound, I now do not want a ghetto blaster sound or one that comes from a fat subwoofer, but something more should it be than now. In addition, the boxes distort when I turn the radio almost to full volume. -but if possible for little money, so as little as possible. There is a mini amplifier for almost 25,-, with 2×30 Watt RMS. Should be only for the rear boxes, here should come also more bass. here the amplifier:http://cgi.ebay.de/…/290568807787?… Now my question: Does the part egg. what? My radio already has 4×45, the amplifier after all only 2x30W. Then I have less than if I directly clamp the boxes?!?!? Or do I see this wrong? AND THEN N N OCH: What else would you recommend to me for a power amplifier? As I said, if it is somehow possible I don’t want to install a subwoofer. The boxes at the back have a frequency starting at 25-… so nice in the bass area. I hope I don’t cause a big headshake with the experts! Can you help me??? Budget max. 100,-. Thank you!
-
Closed bass box in the combo
Hello together, unfortunately I recently shot my radio and my two power amplifiers, which I took as an occasion to re-stretch my entire system :=) I have installed the following in my Ford Mondeo combo: HU Pioneer DEH-P88RSII New FS Axton AC26 HS CRUNCH BMX-6.2C Sub Audio System Radion 12+BR New Amp for Sub Hifonics TXI 3000 New Amp for Speaker Crunch Gravity GTX 4600 New Hifonics Capacitor 1 Farrad The radio is beyond any doubt, especially ha be it I get it new for 250 euros :=) The final stages are initially a compromise, they are enough, but are not comparable with my smashed Alpine MRV-F400 and Rodek R2160. The Axton is for the price an absolutely great system as I think Crunch is scrapped and will be replaced surely soon. The TMT of the Crunch system does not take place virtually at all, neither level nor center are represented by the system sufficiently. But now to my actual question, the sub RnB and Hip Hop are playing brutally. But since I listen to a lot of rock and also like music with fast, dry and hard basses, it’s not my final solution. So I’m looking for a closed subwoofer, which is still able to generate some level and just go to the point of bone dry and hard. From the price he should be something in the area of the audio system because I want to sell it again. What do you think of these m Part here: Pioneer TS-W3001D4 It should come well and it already gets along with a housing around the 15L. I’m open for all suggestions. Greetings
-
New radio – what is the current market?
Hello together, for a long time I had been able to pay attention to the topic of Carhifi with me or my car only in a subordinated way. But the virus is still in me and during the last rides in nice weather it packed me again: I need a new plant budget are in total so 2500.- Euro, which is why I probably also have the plant professionally installed. However, it is with me with dealers in the immediate vicinity rather thinly sown (who knows which in the room 63739 can also w This is why I want to start here with the base and this is the good radio. I had imagined such a frame 500-700 euros. From the performances it should be approximately comparable with my old radio, the Alpine 9815. I write my ideas together: – Operation of 2-way, better 3-way, system active plus sub must be possible, therefore corresponding crossovers – MP3 capability – optically it should fit into a Peugeot 307 (illumination). I have attached a picture of the interior. Alternatively, I can also imagine the solution that you can operate it via the original radio, if it is somehow price comparable possible. The radio has to stay in anyway, because some functions of the on-board computer are controlled via the radio, so it has to remain connected to the bus system of the car. I am grateful about many suggestions, what there is currently so on the market. I would like already a N eugert, maximally a young used one, which then has to be in very good condition. Thanks for your cooperation Greeting Tecci
-
Helix H500 Clarion DXZ958RMC Hifonics compo always broken
Hello have a problem and hope someone can help me. I have a Clarion DXZ958RMC car radio a carpower end stage where a Hifonics sub is running and a Helix H500 end stage where a 13 Hifonics compo is running Now for the second time the speakers are defective only the tweeters are working. What can this be about? Wrong setting at the Helix end stage? What do I have to pay attention to? Or does the power stage make a mistake? Have bought a MB Quart RUA 13 compo set and have vo The first time I removed the hifonics after broken down the “burns” the current ones are still installed but the smell will probably be the same. Is the helix so a fucking end stage or what’s going on? My car radio up to the speakers is not a “waste” installed.
-
Ohm…I’m coming together Ohm my God 🙂
Hello guys, I need your help. I have a subwoofer (not yet, but soon) that has an impedance of 2 x 2 ohms (double-swing coil). I buy 3 pcs of it, which are supposed to be in a calculated bass box. How is this now with the connection to an amplifier? I currently have an amplifier (2 channel, 4 ohms -> 1 ohms Stabil). The MUST NOT be used again, I would also buy another one. But I don’t see through when connecting. 2 loudspeakers with 4 ohms in series are 8Ohm? or how? Thanks if you could enlighten me
-
question about 2channel power amplifier at original plant
Hello My wife drives a signum. He should now get a 2channel power amplifier and a bass box. The power amplifier should be connected to the existing factory radio with the help of a high-low adapter. As everything is connected is clear to me, but I have concerns in one thing. If I have a bass box in it makes sense to turn the bass on the speakers down the radio because the LS can play louder without bass. But since the power amplifier with the HighLow adapter parallel I turn down the bass at the input of the amp at two LS outputs. Can I turn it up again at the power stage, so that the box can play enough bass? Because if no bass signal arrives at the amp, is there no longer to amplify, or do I see this wrong? So far I only installed systems that were connected via the preamp outputs, the problem is not there.
-
Power amplifier wired with sub, to Blaupunkt radio in the sandero.
Hey guys, I have a power amplifier, a subwoofer and a car radio from Blaupunkt. ( Dacia Sandero) The power amplifier is Raveland XCA-200 (2/1 channel power amplifier) RMS is a 1 x 300 watt The subwoofer is a Mac Audio MX Tube 30 with RMS 245 watts The radio is a blue point SAN REMO MP28, which I just heard it doesn’t have a Cinch output. My questions are: 1.The power amplifier has a Cinch output my sub has just like any speaker + – cable to plug in, how do I cable that? 2. Which adapter do I need for my radio that I have the rear outputs as cinch output? 3.Reichts my cable 16mm2 ? Thank you !
-
Car radio, sub, power amp, does that fit together?
Hello dear ones, so I have the following problem, although I am leie about car hifi, but I bought jz nen ford fiesta, and I want to increase my sub and a final level, unfortunately I have only about 150€ available. Subwoofer I have this here in the eye: JBL CS1204bhttp://www.amazon.de/…/ref=sr_1_3?… The question is jz only, where do I get a final level for just under 75€? I found this one time here: Blaupunkt Velocity VA 475http://www.caraudio24.de/…/…-with-850-Wat t-RMS-420-Watt::18949.html Do these two components fit each other? what do you think about it? Furthermore, 2 more short questions, what do I have to consider when buying a car radio when I want to connect a amplifier and sub? & which cables do I need there, have seen which ones with different diameters (10mm2, 20mm2,… ) ?! THANKS for the answers in advance Sil3ent