Category: Ford Transit, Connect & Courier Forum

Hello, has anyone ever made an oil change at the Tourneo Custom BJ 2013 2.2l, 155 HP? Type: Oil filter inside a housing (not the oil filter metal version)? I have difficulty with the fit accuracy of the filters as regards the spring. Have now 4 pieces available (see picture) , 1 original built-in (this is above all manufacturer but unknown) and 3 purchased for the vehicle type (type car sham: 8566 – BFS). But for all 3 retrofit types I find the fit for the Fed It is not suitable to push the filter upwards. None of them guides the spring correctly, in Bosch it even slips into the hole and is then held by 2 opposite plastic noses, which are certainly not intended for it. The other holes seem more suitable, but here, too, there is only a very shaky fit (area) for the spring. Should this be the case? Isn’t the spring correct (outer diameter 26.5 mm)? Does the filters not agree? What are your experiences?

Good morning, so first of all. My wife and I are super satisfied with the new toy. But he has a little Macke. I was allowed to fill the car immediately. The needle went immediately to “full”. The electronics said residual range 50 km. *shock* Since we had a little trip to call the dealer of course. This then called back and said it was a well-known software feature. Now my question in the round.. does someone have the same feature ?

Hi, unfortunately it caught me yesterday too… A stable border pole has left an unsightly cold deformation. My unskillful, simply too strongly distracted. The pole was also only 90cm high, sharp-edged and still stands there as if nothing had been… Running board also got something and the decorative strip of the door. Door goes open and shut without interference. –> because guessing, I was already at the bodywork this morning.. What do you mean at the cost and the repair Urdauer?

Hello together, due to family growth we have replaced our Ford Kuga for a new Tourneo Connect Titanium 1.6 EcoBoost (signature picture I change still! :-)). And directly a few small questions appear: I would like to look early for dark winter alus (anthrazit or black) in 16 inches for the Tourneo Ausschau (Ronal R41 or similar). As tire size should be mounted that Tourneo standard format 205/60 R 16. Obviously the rim choice for this model is not I also think you have to be careful about the RDKS (the Kuga had none). Does anyone have a rim recommendation for me here (if necessary with picture)? Furthermore, I am looking for a suitable boot tub at a reasonable price. There are a lot of offers on the Internet, but from experience I know that half of them are usually not o Does anyone have a recommendation for this? Thank you very much in advance!

Hi, I’m driving a Tourneo Connect with RDKS. Now I bought winter bikes without sensors, because Ford’s complete wheels didn’t have my tyre brand. Here’s my experience: After about 10 km of ride, the BC noticed that there was a problem with the sonsors. Warnings were generated (information in BC) and the warning lamp for tyre pressure lit. That went for about three days (is certainly dependent on the number of starts, I didn’t count). r annoying. Now the warnings are gone and the warning lights are extinguished. That’s Ford step by step! So you can buy winter bikes without sensors. The messages disappear after some time. Greeting, Heilo

Good day, I ordered a custom, comes in the DEZ 14 on summer tires…. now I ordered a suitable aluminium rim from Borbet, but shortly before delivery the dealer informed me that Ford has changed something to the screws, and thus the ABE has fallen. Also whether the rims fit for individual acceptance, is not sure????? On my written request I got a call back of a Ford factory member, which I could quote here, but would be real bad…… eg al…. 0 Info my dealer will also find nothing in the parts lists…… Question to the experts: Has anything changed that has an influence on the fixation of the aluminium rim???? Since the ABE ́s must also have decayed with other suppliers!! I would be very grateful here for every information, thank you thank you

I have a Ford Tourneo Custom Titanium Bj 12.13 since 04.14 on which I still have new car warranty until 12.14, My model has the 125 HP machine and otherwise almost full equipment. My problem now occurred for the second time and because of which I have an appointment with my Ford dealer in a few days lies in the following! If the vehicle e.g. in a parking lot stands for longer time in the sun at an outside temperature of today 30 degrees and I start after the start of the engine and the navigator has just programmed to the desired destination and is not yet air-conditioned and the amaturator board and the interior are still very hot, comes after a short time the system messages “system is switched off to cool down”!! Then the navigator and the display also completely shuts off radio and can not be switched on even a certain time anymore!!! This is of course very annoying, since I still in the summer to Italy and there the temperatures are usually much higher than here in Germany!! With a 45,000Euro vehicle this should not be a topic!!! I hope you can help me further and look forward to numerous productive answers from your side. Sincerely Felix.

Hello here in the forum, has had a Ford Transit Custom for a week. The handler made a connection to my cell phone and it worked. My music from the cell phone was played and phone went too. Now I downloaded a Navi Ap, Navi and music went and it rang. Since then my cell phone no longer works with Sync. I tried to reconnect it. The cell phone is disconnected after a few seconds, shortly after detection. BT continues to function, from the cell phone comes the music , but Sync does not recognize a phone. Thus no emergency call assistant and no hands-free device. I updated the software of my mobile phone, brought Sync to factory condition, completely deleted my mobile phone and reinstalled again by backup, tried with my son’s mobile phone, there goes the part, compared all settings with those of my son, are identical, dealer first knows no advice. So, and now I don’t know any more and would be for a few Tips grateful Greetings Detlef

Hello noise affinity among the FTCustomizers, I have now opened my own topic, because I now want to go to action and in a first step to renovate the bass area of the FTCustom. Underhttp://www.motor-talk.de/…/…ow-adaptor-enhanced-t5227602.html?… (like in the middle) I had already expressed some thoughts on the topic. Now I have made nails with heads & ordered the 4+1 – final stage “Alpine PDR-V75”. It supplies the original Lsp front and rear and the bassbo The subwoofer “JL Audio CP110LG-TW1” is purchased. It fits under one of the two seat benches at the back. If everything is installed, I will continue to look & if necessary take care of the replacement of the original Lsp. Finally, a question: Has someone ever lowered the passenger seat from the console? I want to place the power stage there and it always hits somewhere when pushing forward or back, so that you don’t get it. MffG

Moin people. Can you please look at my schematics? The school is a bit old… If that fits like this, I still need suggestions from the cable cross-section and security size. I’m not sure about the connections of the consumers’ cables. If I connect them as if they were not drawn, they are not grounded. I have a memory error… I’m trying to post the security holder…