Category: Fiat Forum

  • mondeo / disaster car

    Hello together. Would like to get rid of my anger about our Mondeo, TDDI, Ez 10/01, km 67000, 1.Hd.. Experience report: At Km 16000: Central locking automatically locks all doors, even during the ride and with short-term disengagement (Kulanz). At Km 44000: brake caliper at the rear left. Both brake discs replaced (no bulance). At Km 46000: spring bone fracture at the front right (during a holiday trip). Fzg no longer rollable (Ford only took over the repair. Costs for necessary car rental, no indication. Processing of the certificate request took 5 months. At km-stand 67000(current) engine total failure at speed 140 on the highway. Vehicle no longer starts and was towed from the ADAC to the Ford dealer, where it stands since then. Cost forecast lt dealer: Between 250 and 2000€!!!!!!! Sporadic occurred again and again idling saws and unmotivated, independent acceleration without the accelerator pedal being pressed. Of course ro Both rear doors are already standing quite considerably after 2 years. One door was derusted and painted by Ford, the other one is left like this. No question, we have never owned such a car before.

  • restless running Scorpio 24V

    Hello together! For some time now I have a problem with the 24V engine in the Scorpio. The engine runs quite restlessly in idle mode (the engine block shakes), but at increased speeds it gets better but not enough good. In addition, a flap (even in warm condition) can be heard on the right side of the engine. It is not a loud hit, but an unusual and clearly audible noise. The engine has m.E. full power and no oil or water consumption/ With the request for quick tip’s!!!!!

  • Unround motor run ???

    Hello guys, I’ve got a really nice problem. I drive a Mondeo Built February 96 with the 1.6l 16V machine.For some time now my engine has been running unevenly.In addition, it consumes 13.5 l on 100km with economical driving and the values of the AU are far from good and evil. It runs far too fat. Before it ran like a clockwork.Hab driven it with 8l. We have already made the vacuum hoses, the ignition cables, the spark plugs, seal from the Khrümer to the Kat. New Lambda probe and new air mass The values are still bad. I brought him to Ford a few days ago with the task to find the fault. There it was said, the engine and all the attachments are in order. He was also connected to testers. After a calculation of 100€ I was told that it was possible to find the cat. This is to be used and thus the exhaust gases are to be stored. I was advised to blow it out nicely on the track once. Said done.Now he runs to the track. auso sch. as before, if not worse. Do you have any advice? I already put a lot of money into the thing and so slowly I don’t like it anymore. Games with the idea to sell it.

  • Problem with the engine or battery !!!!

    Hello atsamemen am new here and have a direct question to you and that is I drive a Ford Fiesta Bj:91 1.1 L machine GJF and my problem is that car has been packing around since the winter time that means first the car didn’t jump on what I bought a new battery and then everything was ok again and after some time the car does not jump again because it has too little power so comb I decided that it might be on the alternator because it is responsible for the battery charge. So then I decided to drive to the Schrotti and buy me a Lima I also made and have installed it directly on the day as I read here in the forum can man also measure something and that I did also when I start the car with the new Lima and give once gas then it supplies constant 14,10 volts current and if I turn on components like–> light +Fernlicht warning flash system radio ventilation rear window heating then it is i 12,40 volts so when I did all this I also drove with the new Lima 30km so that the battery would charge a bit when I came back (was in the evening) I noticed how when the light got weaker and weaker and the radio went off but as soon as I gave more gas comb enough electricity again so all that went And what is still short, it squeaking in the engine room but since I have been looking around here I found out that it was at the Keilrie because I will also be renewing the coming week but that can’t be the fault or ? Ask you what could it still be ? Can’t it be that the new battery is defective ? Or does another part pulls off the whole stream maybe a mass error ? With regards to mole Sorry for my grammar and my spelling errors do not come from here

  • which door speakers fit in Fiesta

    Hi leutz I want to use in my fiesta gfj 1,1 bj 92 other door speakers they should have the same dimensions because I have no idea my old ones hold because the power of my new radio unfortunately does not scratch out because of the bass so funny. Give you a few dates isn AEG CS MP 530 IR With 4 * 100 Watt 4 Ohm and all snaps like remote control USB port, card slot and is MP3 capable Which speakers can I take the clearly fit un However, my ideas for the price are between 50 and 60 € well and I can still install it if I can’t do it myself.

  • fiesta 96 flair valve play

    hello people, last week I had a ford fiesta flair 1.3 liter with 50 ps of my built year 1996- ? (MK4 I think) see also picture bought, car was hardly maintained, want to ask if you have to adjust the valve play with this type and the adjustment data to do so if necessary or if this is only done with the previous models? (operation manual was unfortunately not more available) then something else: have to repaint some places with my model, but can nowhere find the paint color, so-called ar im kfzschein stands only color : 5 and I have already scraped the whole engine space and still something: the handbrake has to be re-set, does the type usually automatically after that means the brake cheeks are quite worn out? or can you put the even where? would be nice for a quick answer, the vehicle must make as soon as possible well fit for driving because I absolutely need one

  • Fiesta pulls to the right when braking

    Hello, I recently renewed the brake discs + pads and the crossbars at my fofi… Yesterday I noticed, when I brake harder he pulls strongly over to the right… That was not before… What could that be? Greeting Marc

  • Brake discs + pads for Fiesta at Ebay

    Hello, my Fofi needs new brake discs + pads on the front. Found the following offer at ebay: What do you think about it? Are the parts recommended and “safe” enough??? Thank you!

  • Fiesta gets hot very quickly

    Hello together, drive for 1 1/2 weeks a Fiesta, EZ 3/99, 75 Ps, 1.25 L Zetec engine. Very well maintained car, the bigger my shock, that the car already after a short drive (approx. 5 min.) always gets so warm that the temperature indicator goes into the red area. If I turn on the heater, I can just bring it back to the normal area again. The fan goes on, however, only the speed or the engine gets restless when I am shortly before the standstill. 500 rpm and then up again to 900 – 1000 rpm. I most likely tap on the thermostat, but I’m quite an autolaie. What do you mean? If the experts also think that it’s the thermostat, where does it sit if I want to replace it?? The “great” operating instructions say nothing about it.

  • Increase top speed by 5-10kmh

    Hello experts I recently bought a Ford Fiesta GFJ 1.1 50ps bj 93 to do some city trips. Now that I want to go on holiday with a few friends in the summer, I tested the car on the highway and see because it drives as described in the vehicle license actually up to its maximum speed of 143kmh. Since another friend of mine also bought a car Opel Corsa 1.2 45ps bj 97 he did this right with me on the highway it turns out that my car accelerates a little faster but in the end it drives about 2-3kmh slower than itss… so of course it keeps pulling me up and I understandably get on my nerves… so I ask you: Is there a way to increase the top speed from 143kmh to 148-150kmh? And which of these would be the most cost-effective… since I want to drive the car for a maximum of 1 year not much more should be invested. Thanks already… once in advance MFG maj0