Category: Lancia Forum

Hello, I hope someone can help me. I bought a used Pro cee’d 1.4 90hp last week (private). Km approx. 160.000 First registration 2010 previous owner (1) Tüv also new The car ran perfectly until yesterday, but as I drove yesterday to work he simply went out after about 3km at a crossroads. Now he doesn’t stop the standing gas anymore and goes straight out. Also this starts only if you press the accelerator a little bit, but as soon as you start from the Gas pedal goes out. When it runs it shows me no faults in the display, it goes out EPS Öil and that with the key is displayed. What think I is normal. Also performance loss he did not have any noticeable had him of course still driving home so?? Plug and so on suspicion for mader I have checked but could not notice anything. Have an appointment to read out today at a free workshop But vllt someone has had a similar problem before bt, which might help me further. Thanks already in advance

There is another menu where you can fiddle… Engineering Mode: To record info screen and the date of the software version (in my case “191209”). To go to the next image (upgrade, update or as in my case “standard” It works like a huge virtual keyboard with 9 keys on the right side of the screen above the upgrade button (with 1, 2, and 3 above, 4, 5, 6 in the middle – 7, 8 and 9 at the bottom right. 0 is at the bottom left. The date on this keyboard enter and a 4-digit keyboard is displayed. Password is the time followed by the 4 last digits of the software date (1209 for my software) e.g. 14391209 (14:39 o’clock) That’s it! I take no responsibility if you destroy something … Watch out

The following problem, as TFL only have these disgusting yellow-stitched lamps and wanted to use LED lamps. Unfortunately, they are not recognized, nothing happens at the start of the engine. Where could the problem lie? Original lamp is one: 12V 21/5W BAY15d ordered and tested I have the following:http://www.blauertacho4u.de/…-Bus LED Bulb-BaY15d-PY21W.htmlhttp://www.blauertacho4u.de/…Ba15s-P21W-with-CREE-XBD-LEDs-6000K.html both without function though canbus safe!

Hello everybody, have at my Proceed GT 2019 with a km stand of approx. 75,000 km an uneven wear of the running surface and loud rolling noises during the ride (saw tooth hum). It is all series on the vehicle (wheel drive, rims, tyres) and the problem occurred at the Sport Pilot 4. Does anyone else have this and if yes a cause could be found? It is visible on the picture that the inside side has gone away more strongly.

Hello dear processler! Does anyone already have pictures of the Proceed GT in Sparkling Silver or Lunar Silver? Unfortunately, don’t find any “real” pictures in the colors… Also not at google or mobile.de In the configurator these are unfortunately – as I think – not very realistic. Would like to order this week and fluctuate between the two mentioned colors and deluxe white. Maybe someone can help us… 🙂 Beautiful weekend!

Hello people I was busy yesterday because of the speed cameras in the Navi. Now I connected it via WLAN hotspot to the smartphone. Nice and good, works as it should. Now I don’t want to turn on the hotspot on the mobile phone every time to have WLAN on the Navi. LTE Stick is ordered. Now only the question arises which data tariff. Here have 2 possibilities: 4GB data by 5.90€ per month or 3.9 cents per 1mb (102,4kb exact billing) If all this only 2-3mb a month b Needed, I would of course tend to the 3.9 cents/mb. How much data does the navigator need if I am on the road every day, say, 2-3 hours?

Hello people, that the windscreen wipers sit under the hood edge and that one gets them high by the maintenance position (after ignition from the windscreen wiper lever downwards) was already discussed often. What I noticed now in the frosty weather – when the windscreen wipers freeze in the normal parking position the blower of the windscreen does not reach at all with the windscreen wiper, since this falls about 5 cm further on on the disk. That is total crap we Of course, you could always go to the maintenance position when you put it off, but once you forgot the Zonk. I only had the possibilities: rain sensor out and the wiper does not use until everything is thawed up by the heat in the interior or leave rabiat… both is kind of messed up. How do you solve this?

Hello, I have looked at the Kia ProCeed 1.6 T-GDi DCT GT from 2024, and it looks really crazy. I have already read a lot of questions, answers and problems here. Of course, in such a place people who are or were active due to problems naturally gather. Actually I had rejected the purchase already again, but maybe your assessments help me further. What experiences do you have with the – from my point of view – far too small sized engines, The biggest engine in the ProCeed is a 1.6-litre engine with a displacement of 1591 cm3, which generates 150 kW (204 hp) by turbocharging and direct injection. Even with overcautious maintenance, I don’t feel good about the durability of the engine and the connected components. What do you think? Lg

I would like to install the following original KIA Proceed rims:https://www.kunzmann.de/…/…en-4-parts-satz-original-kia.htm?… on a Ceed SW model year 2025! (Registration is still made as only 17 inches in COC) Are there any restrictions then? (wheel nuts suitable? sagging necessary? etc) What are the suitable tire pressure sensors for these rims if I want to use them at Ceed SW? There seem to be tens of variants!?? Thank you in advance!

This question goes to those who have also had their chrome parts foiled and possibly have had experience with it. After we picked up the car on Tuesday with the torturer, we looked at everything exactly the day after that and there have been many defects in our opinion. After the holiday with the torturer talked and all this showed, his statement was the chrome part in the area are difficult to torture! Is that true or does he simply not have the necessary experience, we il that will probably not last long and then we have the fun. We still have some more pictures that don’t look better because this is about the whole car the bad work as well as cooler grill and flaps. He actually has to do everything and make new because repair is not really inside. May/can he refuse ? ( fortunately not yet paid ) or can I agree on it he pulls everything black off me again and he stays on his working time and materialko we could also charge him for that. What is your opinion on this ?