Category: Nissan Forum

Hello to all, I’ve had a problem with my SL500 (WDB1290671F1, 1994, 146,000km, engine M119, LH-Jetronic, 2 distributors) and hope that among you is a specialist who may have experience with such a problem. The Fzg. has been idle for 2 years (650 !/min) and in increased idleness up to 2000 revolutions light dropouts, i.e. the engine shakes slightly. In cold condition a little more than warm. Under load the engine runs perfectly and has power. It starts cold as well as warm. A MB-Hdl. recommended me to visit a BOSCH service. But he probably had even less idea of the SL than me. He also noticed the shaking, but did not know any remedy and has given me 2 cans system cleaners into the tank. Now I have not renewed the resistor cable – I have already renewed the resistance filter again.

Hello I think about getting one of the two diagnostic devices listed. Does anyone have experience ? I just want to work with the SL. Can the CR max do everything the MB3 can….or more? Does the MB3 go deeper and better into the diagnosis only for Mercedes? The CR Max can probably be a complete diagnosis and then displays all the ECUs. The errors are then marked red. With the MB3 you must probably look into every ECU whether there are errors, or? Please for experiences and advice. Thank you

Hello together, I recently added an SL500 from 2002, the vehicle has almost full equipment (Keyless-Go etc.) The problem: If the vehicle is 2 – 3 days without starting in the garage the battery is empty. I bought the car the other day, already with the previous owner it showed the battery indicator in the display. Then a good used battery 74 Ah bought the same, fully charged and mounted in the back of the trunk. Thought everything would be okay, now I noticed that the problem still exists. Have a Bosch ESI tester, which shows me only a fault memory currently: Air conditioning multifunction sensor error in the data bus Another deficiency is: that the seats (massage function etc.) driver and passenger do not work. Should be over the air line under the passenger seat, I also hear an air noise or hisshy. What do you mean? Why does the battery go so quickly empty? Where do I have to start looking for the error? Is that the main reason with the sitting? I can still start the vehicle when I take out the key and then do not start a problem again for the battery.

Hello guys, wanted to ask you about it, unfortunately I didn’t have a board folder at my new (used) purchased SL, because the checkbook is missing, it had to simply reorder. I received quite a few invoices from the previous owner, but I would have entered it into the checkbook. Had been several times at MB branch office, which could see in the system even much more what was done since 2002 after delivery. Unfortunately it has landed in the archive and they can not see it immediately in the PC clearly what everything was done so. Last I was informed that I should report to the Debitors Accounting Mainz by mail. Also from which I have not received any feedback so far. What could I do? The checkbook must be kept (very important for me), of course also for the future very important if I want to sell the vehicle again, understandable or ? Where can I still report? Mercedes must be able to deliver the history, no matter how, the vehicle is registered on me and I think I have right to it.

Hello, I have found that the Wechlser CD no longer works with my 2006 pre-mopf and therefore I am looking for a replacement device. On the changer is “Model No. MC3330”. I’m not sure if I need one with exactly this model name or if I can also use another model?!?!? (Difference d2b>

Hello! Why doesn’t the car start? What’s going on now? The car jumped in with the start-up cable and ran for a couple of minutes. I assumed that it only ran over 1 igniting chair. I then pulled off the cable from 1 and ran again and then ran exactly the same again. I then tried to start only with the other igniting chair, over which he did not run. Car did not run only turns something and red lamp from the radio then no longer burns. Ignition chair changed. Again start-up cable ran, lights from the radio goes again. Then again tried to start again with both connected igniting bowls it does not get turned. What’s going on now????? Can it run on the still old battery and completely empty battery that is in the car? But this has run a little load before when the car has run. Checker shows at 15 and 1 of the igniting chair each 12.5 ca, if the bridge cable is connected.

I had the half-hour pleasure of moving the new SLS today. I’ve been driving a car for 35 years and I’ve been sitting in a lot of places, but the part beats everything. I think I’m addicted…