Category: Nissan Forum

Hello, I drive a Nissan Leaf, built in 2023, which is equipped with the new Nissan emblem. The front logo (part number: 52890-5MP0A) has an integrated lighting that can be activated via a 12V power supply. I am now looking for a pre-assembled plug that fits directly to the existing connector of the logo. Does anyone have any information about this or can help me? Thank you Best regards

Hello, I h open you can help me. Need a Sport ESD for my 1.8 Turbo Silvia Bj 1985. Can you tell me any pages of tuning providers? Would you like to do even more things, but ESD is important because my production pot is through. What can you recommend to me? (Newly changed to Nissan here and also new) Thank you MFG Phil

Hello municipality. Have above mentioned vehicle with which on the passenger side permanently kale air comes. For me it looks as if the flap adjustment no longer works. Maybe you can take the climate control once resets like with my Opel or there is for it a separate spare part which can then be exchanged or is this a larger act for repair e.g. kpl. blower immerse 😉 Thank you.

Hello everybody, who of you had the update done for the call back PS3C0? Could the update be played without any problems? Mine has been standing in the workshop for 2 weeks now and Nissan doesn’t get to play it up. Nox sensors have already been exchanged. Would I be happy about your reviews to estimate a little what’s ahead of me ??

Hello, would you still buy an NV200 (box car) with the mileage (270.000)? Timing belts renewed at 220.000km! Checkbook maintained! Price > 4800€ The dealer must give 1 year used car warranty, right? Please for your opinions!

Good day. I have a problem with a Navara d23 from 2021. Vehicle jerks when the engine is cold strong. When it runs 40 s it is quiet again. LMM, AGR and EGR is new. Low pressure lines are fine. Suction bridge cleaned since that is the fault, was full of oil slurry. When you pull off the EGR it runs quiet in cold condition. When the plug is re-plugged the engine jerks again. Values look good from EGR regulates normal. Think a temperature sensor could cause problems pressure high pressure pump is constant at 600 bar in idle. I would be very pleased about a help. If you have had or know this error before, I am very grateful. Mfg bjoernm

Hello, I own a Navara D40 V6 automatic. Recently I have the following problem: no power or only low. Automatic switches very hard from the 4th course. In the error memory is the code P012B-7A. I have renewed 2 sensors so far. Once the charging pressure sensor (below the safety box in the engine compartment) and the sensor which lies approximately in the middle of the engine, just before the front wall. Both brought no success. Are there any more charging pressure sensors? Did you also have the same problem? Ask for help or solutions. So the car is unfortunately not mobile. Thank you already

Hello together, I was offered a Nissan Murano base built in 2005 with 146000 km for 2000 Euro, TÜV new. Since I like this car I would like to ask here once in the forum if anyone who knows about these vehicles is there. Would be very grateful for a short answer. Recommended purchase or not. Thank you Greeting Jürgen