Hello all, I bought a G class some time ago. Year of manufacture 2016, model 2017. In the equipment list (purchased used) I recently saw the equipment code ME2 Output Increase. Does anyone know what that can be? Thank you and best greetings.
Category: Nissan Forum
-
V6 CDI OM642 Manual Starter change W251 V251 W164 W166
I had to change the starter of the R-Class on the weekend because it turned too slowly in the cold state. In the warm everything ok at home, without a stage. Since this is a really great task, I would like to let you share it. So maybe one can avoid the one or other cursing. I think that it was never really intended for Mercedes to change the starter, at least not when engine and gearbox are stuck in the car… If you know what to do and which tool to use I needed about 3 hours. However, it should be possible with the instructions in half of the time. 1. Unscrew the belt under the passenger seat to the right and secure – drive the seat all the way back to the right. 2. Extend engine cover 3. Extend air fluter housing in driving direction right 4. Unscrew clamp from the trouser tube / cat (behind the cylinder head) 5. Screw holder Trouser tube / cat (behind the cylinder head) unscrew SW13 6. To do this, you need a sawn off 16er ring key (approx. 2/3 handle length), thick leather gloves and a lot of power. Maybe there is also a special key from Mercedes. But in house use definitely nothing else fits. It is also not possible to get through the window in the wheelhouse, as the spring leg is directly in front of it. 7. Screw off the two screws from the exhaust holder on the gearbox. Now the cat can be pressed to the side as far as possible. 8. Dissolve screws from the starter. This only works with an overlong 1/2″ tilt extension 500mm (3/8″ probably also) with plug-in nut (and the upper screw additionally with joint) The extension is to be groped past the exhaust pipe/cat and holder. Very important: Please let the screws plug in! 9. Pull out a piece to the rear/top of the starter and then lie down at the engine bearing so that you can move from the top to the 10. Unscrew the two nuts SW10 and SW13 for the cables from the top/front. It is also best to use an over-long 1/4″ extension. 11. Fumble the starter backwards and take it down through the small gap between Kat, Karosse, and motor/gear. The installation then takes place in reverse order. Have fun screwing!
-
R500 no longer starts
Hello, a happy new year. Or not. Just wanted to get our R500 out of the garage after 8days of service. But don’t start. At the end of a small video. There was also no bridge, had thought battery too weak. But was actually from last year. Had just tried again, of course not. But strangely enough the pointer from the clock still ran several laps although I already had the key out. Funny or sometimes overnight over the battery connections in the engine room Charging ? Battery now has about KI 10,2V.
-
On the way with the G A picture thread
On the way with the G…a picture thread of your journeys.. from the beginnings to today Free to Henryk M. Broder With the G-Class you experience the eternal youth …quasi … A G in the cornfield between flowers and straw And the stars shine us anyway…. G in the forest G on road G with sunrise / sunset G in spring / summer / autumn or winter G in front of the ice cream parlour, behind the ice cream parlour G in ….egal…. main thing G …. or with G
-
SL450 Built 1980 with 160kW from USA??
Hello, I’m interested in an SL450 from 1980. The vehicle is offered with 160kW/218hp. If I’m not mistaken, the 450 ́s were exported to the US with less power (bad quality of the gasoline). Is that true? Furthermore, the third brake light is missing with this car. That was in the USA at that time, right? In advance already thanks.
-
New G63 (W465) – Shock absorber defective?
Hello together, I picked up my new G63 in Affalterbach the week before last – which was of course an absolute highlight!. Unfortunately, after about a week I noticed a poltern on the left, when I drove over unevenness. The noise occurs especially at speeds below 50km/h and then, if you do not drive at the same time each axle over a unevenness. It sounds like a component has played and would “poltern” against it. Interestingly, the poltern at the versc Here are the driving modes (Comfort, Sport and Sport+) less, especially in Sport +, What could be connected with the AMG Ride Control suspension. Now the chassis and the vehicle is of course very new and Mercedes and AMG advise just whether it should not be replaced… Very much to my pleasure. Has any of you had similar experiences or a tip what it could be? Best regards and thank you very much for the round!
-
Sl R107 engine choice ??
Hello, I’m thinking about buying a nice R107 because I’m already dreaming of it my childhood. Now I have no idea about the engines at all. He should not be a everyday car but honor what to be for weeks and the beautiful days of the year. Which engines are really recommendable? I think the 280er would be enough because racing can’t be done with brakes and suspension from 30 years ago anyway. But is the 280er also empfelenswert ? or rather a 350er ? i de nke the 450 does not have to be, but I just want to know which engine is really to be recommended or whether it is only a matter of taste ….? and what should I pay attention to ? so general weakness etc … thank you in advance ….
-
Leave the car standing longer – what to do?
Hello, I have the SL 560, from the end of the 80s. I would like to hear from you your experiences what it is like if you leave the car untied for a long time. What should you do with it no or little damage? I think that there should be enough gasoline in it so that nothing dries out in the tank of seals or what rusts; disconnect the battery; park dry and cover. One does just that, the other does so. But what would the facts be more correct 🙂 I red e park here already really from a long time. Maybe even unsubscribe, since it does not really make any sense financially. That would be months if not more than 1 year. Evtl also has information about parking possibilities to itself (Room Berlin). I wanted to hear from you before I contact Mercedes Benz directly. I thank you already for your experiences.
-
Has someone already made practice experiences with leather Flamenco red in kombi with Diamond stitching
Hello Forum reader, I have some question what your experiences with the color Flamenco red are. Does the color remain long-lasting? (grey/blass) Is the color time bound? Does the color incline more to red or too brown? In addition, in combi with Diamond stitching (example picture) Do you remember what is in rows by the pattern? Does the pattern stay in front/shape for a long time? For the time being, thank you. Gruss, Hans
-
SLS – looking for carbon parts and steering wheel
Hello together, after four years of SL55, two amg-less years I finally hit again and bought a used SLS. two things I would like to optimize on this vehicle. Does any of you know which company produces the carbon parts for this car? I am looking for the engine compartment cover made of carbon, which as a first-hand part costs more than 6000 euros. That is definitely too much. And does anyone know which company produces the steering wheels for AMG? I have a special wish, de maybe someone can help me, also per pn! thank you and vg from Ulrich