Category: Peugeot 3 Series & RCZ Forum

I had a 306 Roland Garros for a long time and unfortunately had to separate from him. Now there is a 306 S16 for the debate, very fine car but I can’t find any tests on this car on the Internet..can anyone help me? Who has experience with this car? Thank you very much, maik

Hello, I have been driving a Peugeot 307 SW HDi FAP 110 2.0 liter for 10 months now. EZ: 08/2003. The following problems could not be solved: 1. Quit noise when switching on and off the engine. This problem is probably due to the double-window that has been reinstalled 3 times with me. Now also this disc squeaks. My question: Does someone have this/s experience/problem and can someone tell me what was done with him/her to solve the problem? 2. Quiet Quitchen I can’t say much about this – I didn’t pay attention when the workshop master explained that to me. 3. Vibration of the car while giving gas, so a little more acceleration. So the problem is only when accelerating. Please help me!! So slowly I feel a little stupid, especially when I drive into the workshop the engine is buzzing without giving anything of itself X(. I hope someone has had the same experience and can get a If there is any interest, I will be happy to keep you informed! But please, who had a similar problem, report to you! THANK YOU!! David

Dear car friends, I am very desperate. I have a Peugeot 309 II, 1.4 petrol, year 1991. My Peugeot 309 was standing in the yard for half a year without movement. The battery was completely empty. Just the ADAC gave me starting aid and the car also started immediately. Only after 100 meters the STOP signal went on in the amature board but the car drove still quite normally. After that the temperature indicator quickly rose over 100 degrees. After another kilometer I turned off the car. Then I wanted to start the engine again but it was too little power for it. But the red stop light in the speedometer lit up at least very weakly. What should I do? I’m very desperate. Chris309

Hello to the 306-acquainted among you.. at the 306 XR series 1 my mother always lights up a yellow light when pressing the brake pedal (see picture). For what is this now exactly? Unfortunately there is no operating instructions for the car anymore, and I don’t know so much about Peugeot. I thought about the wear indicator of the brake when I was using the lamp….I have checked the coverings, and these still have 4 mm thickness.. Therefore I am no longer sure, because at 4 mm the wear should be checked, and these have 4 mm thickness.. …has someone got a hint about the remote control of the ZV? It doesn’t work anymore, even though the little lamp in the key lights up when you press it.. Greetings to your friend