Category: Opel Omega & Senator Forum

Meal with each other! Yesterday evening it was now so far-Omi was finished. Still gave a little problem with the tap sensor, but was only wrong connected. I must say, it sounds like new. No clattering hydros more-though not changed-no Ruckeln, nothing. Yesterday I had been in Braunschweig with a friend (A6 TDi bought, he wanted to get out on hell no Omi…) and at the same time glided smoothly with 2500 to 3000 revolutions. Completely without any problems. n almost 500 km, think that got the engine better than to fill in the starting phase with short distances. Unfortunately I forgot the broken piston at my brother-in-law, otherwise I would have put in a photo. But I’m going to do it. Well, hope I have some rest. With the new motörchen he has to hold for a while! Again the done works: -cylinders drilled and hoohed -excess piston installed -crank shaft polished and finely-lighted -all crankshaft and conrod bearings exchanged -ve ntile newly sanded valve shaft seals as well as all other seals/simmerrings/cylinder head screws renewed doesn’t sound so wrong or?? 500 km, then there is new oil and new filters, then I will increase the speed times up to max 4500 revolutions. So, I finally have everything together, exams in the bag and Omi runs again – sometimes life doesn’t mean so bad with one-but just sometimes… Greetings from Leipzig Sepp

Hello, now it’s time it has to be an AHK for my omi. My question to you has someone experience about the part as such Do you have the original part of Opel or from the accessories e.g. Rameder etc. Ask for your experiences

Hello everybody! It’s time to change the timing belt again. I’m now at the 3rd change (i.e. 180,000 km). I always thought that the water pump would only have to be changed at every 2nd interval. At ATU I was advised to change these also at the 3rd change, otherwise the new, tenser timing belt would be too heavy for the old wapu and this could lick. What’s right? What do you advise me to do? Greeting Websterstar

Hello people I’ve recently been driving Omi or how to say in Switzerland rather, oh…mega (in a bad sense) driver. I have a 98er 2.0l v16 Caravan am actually rather VW Passat enthusiastic but somehow fell in love with this Opel My question is: My engine is actually a petrol engine sounds but like a diesel is this normal with this model or could there be a problem? Greetings from Switzerland

Hello Together Drive an Opel Omega 2.6 Bauj:2001 Km 162000 bought by a retired born 1930 top maintained, not smoker, gapless book maintained with full equipment except city heating. I immediately fell in love with the vehicle,only I now have a problem! Have noticed in the cooling water oil a caramel-colored thickness liquid. But keeps the cooling water temperature as nailed and no water in the oil. Smoke about a 1/4 liter oil at 1000 km.The vehicle was at m but never too hot that the ZKD could have given up the eaten. (Bin since the purchase 20000) I only read here in the forum and then pushed on it that it could be the oil cooler. Have the oil cooler now expanded (Habe 1985 on Peugeot learned, ewig her and already 20 years from the occupation) but could not have fixed any fault or hole in the oil cooler. Build the vehicle only at the weekend with a new oil cooler together. Have the oil cooler learned now (Habe 1985 on Peugeot, and already 20 years ago I used it as well as well as I can not have a stomach pain in the city. But now I can not have a good taste.

This is the addition of the weekend,Bier and Bratenl! A general recommendation to the alternator is to always have an overcapacity of approx. 20 A in comparison to the power consumption. With the multimeter – while the respective generator is charging the battery – measure the voltage drop between the battery plus pole + and the generator output B+. The voltage drop must in no case be my as 0.4 V, otherwise bad connections or a line error can be suspected. This check and if necessary fix! Errors in the charge control lamp current circuits. Function of the charge control lamp or the circuit by connecting Kl. D+ of the generator belonging to the charge control lamp circuit to check the mass. -Note! Charge control lamp lights up: The error lies in the voltage controller, or the light engine! -Note! Charge control lamp does not light up: The fuses in the charge control circuit or control cable to the charging circuit!

Hello municipality, I was stolen last night the roof antenna of my Opel. Very nice looks the thing on the roof now, so the question is if you can screw up another. Does someone have experience with a maybe better reception ?? Thank you in advance

I have a question for you. What about the rust at the Omega B? Mine is built in 8/99. Do I have any problems to expect? I saw one that was already rusty on the body the other day.Or does this only concern vehicles before the 98 model plege? Thanks already in advance!

Hello dear community, I need your advice. Should I get a new engine or rather make all the seals new? So my big one has now already cleaned 215 tkm down and I have it only since last summer. The previous owner had unfortunately not really taken care of it. I have already done some things concerning the engine like e.g. intake system and various hoses made new. new nws. He still has the problem with what I close to the empty-wheeler. The oil tank seal is leaking, the vd has a hairris and the oil change is soon due. I wanted to take the tooth belt with just about 100tkm and to install it immediately. Probably the valve shaft seals also have to be made with. My neighbor who also has 2 omega Kombi x20xev, thought that it was better during this time to take a motor with only about 100tkm and to install it. I am afraid that the new motor will soon again cause problems. But also that my new tire belt is not made clear with all the new ones.

A friendly hello to your round. I have a problem with my omi again. On Tuesday on the way to work quickly still filled. Omi jumped well after about 500 m the omi goes out and did not jump on. On the test valve there was no pressure anymore. So new pump bought and changed. Nothing happens relays changed without success,Relais bridged pump runs. I now no longer know any advice. What can I do anymore ?????????? Thank you already in advance.