hallo.use necessarily the technical data of a Kent camshaft for the c20xe.name ast1602.the wave is already older and at Kent no longer in the program
Category: Smart Forum
-
Cih cylinder head How do I recognize which one it is?
Hi guys, have here still a cih head with large valve, believe 46/41, how do I recognize from which engine it originates? could also be that r is machined. on the camshaft stands DRM engraved by hand on it.
-
Manta B starts but WHEN I DRIVER out again
hey people in my last post I have described that my manta b Gte always runs out after the start… have now cleaned the fuel lines tank filter and pump… the ignition set again and jetz remains the manta already…. I can give in stand on gas, he also takes up that well over all speeds, … so quickly make a test drive!—> because also the new problem The manta drives easily only when it rolls and you do a little more he wants to give gas starts to jerk, turns at most up to 3000 u/min and if you then go off the gas for a short time, the manta goes on again… after waiting for a few minutes he starts again without any problems and then the same game from the front.. someone ne idde as I can eliminate it? Mfg Martin
-
Install airbag sports steering wheel yourself ?
Hello guys, I have ordered an airbag steering wheel in sporty design and am not sure if I can install the part myself or if you have to deactivate the airbag to install it. If so, I have to go to the Opel dealer. Who can give me a tip ? For your help in advance best thanks. Greeting Andi www.andiruf.de
-
To Senatorman ask for help
Hi have been “almost proud” owner of a Senator-B (C30SE) for about 2 months. But I noticed some defects. 1. Push at 4000 rpm has been off for about 3 weeks (have already checked underpressure lines, everything is fine. Dual Ram switches up at exactly 4000 rpm and the underpressure is maintained even at longer periods of time. The petrol pressure regulator probably pucks, can it be that the controller does not work properly anymore? Have also already read out the error memory but except the The LED on the passenger side only flashes (system error according to the manual), which all 4 sensors are flattened is rather unlikely. Would have liked to read out the fault memory but the suitable heat cable is not available on my diagnostic connector, just as the heat cable for the ABS is not available. 3. ABS does not work. I already found a plug and the matching coupling (Schwartz-Red cable) plug was pulled out of the clutch both plugged together. After that came a very noisy noise from the engine compartment, therefore I removed the plug again. Can it be that the ABS pump is defective ? Can I just replace the pump like this ?? New or used ?? Omega-A / Senator-B ???? Why is my diagnostic plug used the heat cable for the automatic transmission, although I have a have a switchcar ??
-
Oil consumption..can this explain to me jmd???
Hello, as I already wrote here I repaired the engine from my astra (C16nz).. Now I have the following problem, I have driven since about 1400km. When I changed zkd and zk also took part in the oil change. Stand was then at max. then 400km driven, oil level checked, then he was only about at the half, well I didn’t think about anything and felt up on max.. then this morning after I drove about 400km again looked after, oil level was thism al under min!!! approx. n half cm. I drove today 2 times 300km at the piece.had refilled and oil level checked about all 100km on the ride.. this time he lost nothing / consumed, looked again when I arrived, and oil level was the same as I started??? The km before I always drove short distance so about 30 to 40km, and today the 600km.. can the jmd explain to me???
-
Valves burned WHY ???
Hello guys ,I had 4 Opels in the last half year with burnt valve (1.6er 8V, 1.6er 16V Astra-F/G) It was every time with the second cylinder the outlet valve. What is this? How can you prevent this? Thank you and greeting S.L.
-
Cover under the engine?
Hello, have a question again ! And there are vehicles I think before all Audi and think VW have such a cover ! What I’m interested in is why Opel doesn’t do that (at least I didn’t have one yet) that would have to be good for aerodynamics or could the engine get too warm (but then the others would have also Probs)? For the environment such a cover would be positive even if a motor sabbert! MfG from the beautiful Allgäu
-
What’s actually against a row-5Cyl?
Hello guys, I’d be interested in why Opel doesn’t go away from the, I say, unloved, V6 and builds a row-5cylinder ? I’m thinking first of all of fuel consumption and possibly also of running quiet !?! MfG from the beautiful Allgäu
-
What does an engine use on the test bench?
Hello guys, this question is probably only addressed to a few, but it would interest me very much (e.g. a C20NE) ! Hello Reinhard, I know, I know MfG from the beautiful Allgäu