MOTOR-TALK

Category: Smart Forum

  • Z20LET – high water usage at full gas

    Hello, since recently my Z20LET from my Astra consumes a lot of cooling water. However, only if I drive faster than 120 km/h. I stay under it the consumption is almost zero. Have straight the system subjected to a visual test, from there is also no crack o.ä. to determine. Does anyone have an idea? Greeting

  • Light bulb problem from Opel?

    Hello, so also with my current 3rd Opel I have now found that Opel has a real light bulb problem. With my first A Corsa already constantly rear lights, stand lights, headlights etc. have given up the mind. At the 2.Opel, a B Corsa, it in addition to the front and rear lights have also gradually abandoned the interior lighting, cockpit etc.. Now with my Omega B I have already had to renew tail light and brake light. Also it has already e ine pear defused in the cockpit.. Is that a general Opel problem or what can it be???? Greetings ~Babe~

  • Cooling system c24ne

    Hello I am with my ideas at the end I have here a C24ne which builds on the cooling system very strong pressure on have made CO test in the balancing tank which was negative has no water in the oil or oil in the water cooler I have already aired several times but without success. Maybe someone still has an idea !

  • ZK defective??? X20XEV

    Hello, I just overtake my engine because he needed water, I noticed small cracks, they certainly have nothing to do with the water structure, but still would like to know if the cracks are bad… Have a photo attached Mfg

  • Diesel miracles ????

    Hello guys, the following problem !!! With my Omega B 2,5 TD Bj:1998 I have been observing two tank fillings as soon as I go under the 20 he mark on the tank watch and I want to start my car that he starts badly. And sometimes I also have a performance hole at about 90 km/h But if he has more in the tank the problem is not there !!! Thought already on the glow candles, but I made them new. So now I am finished with my Latin. Does someone know the problem and knows RAT ???

  • Problem, can you plan an x18xe?!?

    Hello, I have a question. I drive an Opel Vectra B, 96, engine code X18XE, KM 77000 KM. Unfortunately, it disassembled the cylinder head seal. A water channel is inward into the combustion chamber. Now I can let my question plan the head or does not work with it. My mechanic told me that you can no longer plan every head and the X18xe is probably one of them. Could one of them help me since a new one is quite expensive. With a used one I can I’m not sure if he’s still there. mfg Asco01

  • Rugging at X12XE

    I know there are already some issues about this problem, but they do not help me any further. I hope there is someone here who still has an idea. Problem: 1 Idle with warm engine 2 The speed after starting (cold engine) slightly exceeds 2000 and remains there for about 30 sec. was replaced: Ignition unit LMM AGR Lambdasonde throttle valve was cleaned and the air collector and hoses also. (The small hose from the valve lid goes on a plastic stub that is to be installed?!) Motorle MKL does not shine! I hope someone can help me further, so slowly it becomes expensive to exchange things for good luck. I also don’t think of any more.

  • GT and Saturn Sky / brothers or twins?

    Hello, I am looking for information if there are any technical differences between the new Opel GT and the Saturn Sky red line. Are the vehicles just similar or are they largely the same? Does anyone have information, expertise or does anyone know where to read this? Many thanks for the help in advance! Greeting, oberon30

  • AGR valve — coal mine?

    Hi guys, I used to dismantle the AGR valve at my Ommi (Caravan, 2.5TD, Built 95, 130 TKM) for fun (???) and just wanted to check the hose mounting. The valve inside and also the cracker looks like a coal pit, so that extra filtered air goes through, abundantly stained with Russian deposits. Question 1: is this normal/unobtrusive and does not require any action? Question 2: If it makes any use of anything, how do you clean the crack of Russablagerun? gen? – The exhaust of my earlier 2-stroke moppeds has always been burned out for cleaning, can it be done with a casting part? – Or only once 🙁 Looking for answers – Ludger.

  • Connect voltmeter and amperemeter correctly

    hello people, wanted to insert two additional instruments in the omega a at the bottom. one volt- and one amperemeter. this has an indicator from -60 to +60 ampere. 1.where do I connect the voltmeter? Has two connectors) 2 where do I connect the amperemeter? (has the connection BAT+ and ALT-) which cable cross section do I have to get? what do I have to consider? think that the lighting of the two instruments can be simply connected to the ash cup lighting or so. thank you for your help. mfg benjamin