Was on the Sunday on the way home like my Omega suddenly after 30km no more gas had accepted. There came smoke from the oil cover and at the air filter box. He was then dragged to the workshop and the turbocharger looked, but this should be ok. But he probably could also have let oil through. What could he have had? A buddy said a crack in the piston, had had had them with the BMW of the series more often. No engine lights went on or so and he can also start. Had to drive by train to home and let the Omega stand there.
Category: Smart Forum
-
Engine X20SE runs unround
Servus, have a question….or several of my Omi since I cleaned the throttle valve very unround. MKL goes on more often, but again. Oil filter of the 16V in the crankshaft venting is already installed. Plug all pulled, cleaned and plugged more often. Liquids all in order. Tubes all clean and flasheblank. Intake tracked with start pilot sprayed, no fluctuations. Today I found that my Omi from the oil filling opening “qualts” after I opened them. I still have the assumption that it is the oil spills which are led into the throttle valve. Now my first question: when I read the fault memory I have to pre-clamp the battery? how long does the control device notice the error messages? I can also read the error memory when the engine runs (does not have an ODB device) Office cling method… My second question: does a defective, undichter exhaust (end sound silencer) to the engine run noticeably high? 16 error code – no error rate – 24 – no voltage change of the battery.
-
Interior Quality Omega B Facelift – Review?
Good evening together, I’m on my way in a lot of long distance soon and seriously think about getting an Omega B Facelift. Today I put myself at the dealer around the corner times in a limousine (2.2 Dti, Bj 02, 178 Tkm) and was a bit disappointed by the interior quality. Admittedly, the car did not make a well-kept impression all around, but I noticed that the door linings were quite scratched, the light switch and the keys for the NSW sat relatively clappy in their frames, the center console knarze when pressing on the wooden frame and the ashtray only half drove out and sat quite clappy in its bracket. Everything only made a semi-solid impression. Are you on average satisfied with the processing of your Omegas? How does this look like with you? It would be my first Opel, I was previously in a Passat Bj 02. Is it very enthusiastic about the face lift time of the B Omega “sprünge” in the processing quality, so that there are improvements from a certain production period? There is a difference in this between the noise level of 4 and the rest of the cylinder?
-
oil in water problem
hello people have the typical oil in the water problem in the C20XE. today I have broken down the head and it was clearly not due to the head seal. so there must be a hair crack. since unfortunately I do not have to see it to someone who can do this. can you recommend me someone who can do this?? best from Austria. or also from Germany I have to send the head. before I forget is the 700 head mfg
-
Calibra battery does not charge
My buddy has a Calibra with the 8V engine in it bj. 92 and he ran 114tkm. After that we changed the V-belt and he wanted to push the bolt in the bottom of it mine he that it has lightly sparked (yes next time we make the battery off). Since the charge no longer the battery. We have already another used Lima built in and with it is the same problem. Tomorrow we will try another one again. Pathogen power gets him. The control lamp lights up a I haven’t tested them yet. I hope you can help me, but maybe we’re just bad luck and both are screwed.
-
high consumption c20xe
Hello, I need some help, I’ve had an increased verb with my Astra GSI 16v for a long time with short distance/city traffic. In the past this was always 8.5 liters. Now I’m at 11liters. Today I’ve only driven long distance 300km with ca120-130Km/h, there’s the consumption in order: 6.5liters. I’ve been driving the car for 10 years now: Astra GSI 16V Bauj.1993 C20XE Motonik 2.8 KM:Stand 233000KM were renewed: Air mass meter, Lamda probe, Thermostat, Termofühler both, cranks I have the impression that the engine is running too fat. Where is the idle control valve for the engine? The design is different than with the Ecotech engine. Can you clean it? Unfortunately, I did not find anything suitable with the search function. I will also put the same post into the Calibra forum again, so that many people can help me, hope this is ok for you…. Gru ß Sid
-
Water temperature indicator
Hello, my temperature indicator is always about 2mm above the blue area. Where does it stand with you? 2,0l NE motor. I think that’s way too low and maybe the thermostat that opens the big cooling circuit is always open. Drive the Calibra only recently and don’t know it any different from it. Michael
-
Motor doesn’t spin and turns up the rotary zalometer when starting
Hello friends I am proud owner of a Calibra A for two days.I bought it first hand for 250 euros because it no longer starts.Now the following vehicle was equipped with a Wfs this I expanded today, because I saw the error here.Have before compression,Zündfunke looks everything well. And now the engine no longer goes through and when starting the rev indicator goes high Super thing who has an idea here??????
-
Hello, I’m the new one
Hello! I recently bought an Omega 2,5td Caravan construction year 8.98. Was also often in the workshop with a lot of repairs, luckily everything was running over Kulanz. Now I have a little something I want to repair myself and have the first problem. The wiper water nozzle on the passenger side has too little pressure.The water does not even get to the disc. Will probably be the hose leaking I already thought I could. But I did not know that the hose inside through the body of the bonnet is running.How can I get there.The cables for the nozzle heating run through there too and I don’t want to break anything.I already say thank you for your answers.
-
I once had my omega evaluated
Hello Omega Freaks. I was at the friendly one today and looked around for a caravan. I myself have a limousine with the following equipment: 2.0-16 V , Sport , Built6/98 , km : 53000, TÜV a year ago without defects, accessories : metallic, Automatic , air conditioning automatic , onboard computer, fog lamps, 235/45×17 on Twinspoke rims(by Immscher), CD radio , Xenon lamps , double tube stainless steel spuff , the rest is included in the sports equipment . The car is accident-free and very well maintained The only drawback is a small scratch on the left rear wheel. The dealer offered me a payment of 5500 €. The vehicle I looked at should cost 17.500. Because of the small scratch he pulled me out of 1200 € !!!!! (the whole page must be painted). When I asked him once if this is his last word, he meant: highest 7,000 €, if I should take a new car. What do you mean, but I really want to sell my Ommi because I have a Caravan.