Category: Subaru Forum

Hello, I have a question about the upcoming inspection. I own the Seat Ibiza Cupra Built 2013. It has a Dsg transmission, and now has 69,000 km on it. The workshop says I have to change the transmission oil now, is that right with the KM? I heard without the transmission oil flushing is the change of the Dsg oil unnecessary, is that right? Another question is whether each workshop can and how this works and whether you can control it at all, whether the actual oil The maintenance booklet says something about DSG gas change, how does something like that work and when can it be done? Now my last question, when is the change of teeth coming up, at which mileage or after how many years of use? Thank me for the answers and really appreciate it.

Hello people, I drive a Seat Ibiza 6L BJ. 2006 with the 1.-4 75hp engine… The vehicle has only 82,000 KM down and there is already something clacking in the engine room. This noise only occurs when idle or accelerating.. not if you have the gear in it and let yourself roll. When the engine is cold you hear the clacking more clearly.. as soon as the engine is warm you have to listen a little more because it becomes quieter… the clacking will be faster with the speed! So now to my question… What should ic h do it now? Should I go to Seat and have the car checked? I didn’t have to deport in front of the car now… What could that be? By the way, the car is fully stocked at Seat and only 5W30 oil came in! Today I wanted to try 10w40 from Liqui Moly… What do you think?

In a small accident my passenger mirror was torn short from the anchor. But not deformed or kpl away. I tried to put it back in the right position. I managed – almost – to get it. I tried to put the fixing of the screw hole, which was slightly bent, in the opposite direction, as the blow was on the mirror. Only it still stands a little too deep and you can also see it no longer “sats” on the door. See picture Is there a way to get it back on its own? A repair shop wants € 150.- and that’s not worth it, because the mirror can be adjusted quite normally. But it can’t be driven as high as the driver’s mirror anymore. So it sits a little too deep. All functions, incl. folding, are given. So only a beauty error.

Moin! I drive a Seat Ibiza 6j (75ps) For this I need a new battery. I have uploaded a picture of the currently installed one. Now to my question: In the net I find mainly batteries with higher Ah and A indication. Does that matter? Do you have a recommendation for a suitable model?

Hi guys, I have an unusual problem, namely my passenger door from Seat Ibiza 6L built in 2006 (2/3 doors) can’t be opened any more. The curious thing is that the door lock (microswitch) gives noises when I lock or open. Unfortunately, the door handles do not work, you can pull until the doctor comes but the spring prevents it in the mechanism. I renewed the door lock last year against a new one. I also have help, how do I get the door wied he’s up?

Hello, I have a Seat Ibiza from 2006. I wanted to install Apple carplay radio. I ordered and built in shortly. Now I have the following problem. – in the stand everything works – as soon as I go off, my screen flickers – sound goes away and comes again and again at long intervals for 1-2 seconds – the lights from the radio are however continuously on during the ride – when flickering it shows on “Reverse Camera”, but did not install the camera. So bevo r I start driving I have my CarPlay on, as soon as I start to flicker the screen and when flickering is at the top left “Reverse Camera” Now my question, what can it be? PS: it’s not a wobble contact!!

Hello, With my Seat 6L the steering aid went off from one second to the other. With VCDS read out… 1 error found: 01309 – Control unit for steering aid (J500) 49-00 – no communication sheet protection on the battery is in order. Today came the replacement servo pump. Built in and power on it, exactly the same error message. You can delete the error, but appears immediately after a few seconds. Someone a tip where the error source might still be? Thanks e

Greetings municipality, the Ibiza my wife has recently caused problems. When giving more gas, you notice a jerking. Especially strongly you can notice it at the moment when it is cold. I tried a new sensor for the charging pressure, but the error persists. In the error memory he makes following errors. 4167 – Encoder for charging pressure (G31) P0237 00 [00100000] – signal too small It can be deleted but still drive for some time he comes back and the jerking exists then again someone had ideas or the problem before? Vehicle is an Ibiza with 1.0 TSI (115 hp) and DSG, built in 2018.

Hello dear people! I have been the proud owner of a new Seat Ibiza for a few days now. I never used to drive a switchcar, only diesel and other automatics before. Therefore, a question about the gear recommendations that the car makes. According to all that I have talked to so far, you can’t drive petrolers under any circumstances at all. According to your own recommendation, it’s undertoury when he sounds a bit like a treacherous. I know, catastrophic Description, hope you still know what is meant. This happens with the car at 1300-1500 rpm. Nevertheless, the gear recommendation of the car says regularly that I should keep the gear. The following example: At 50 km/h on the level road I should use the 4th gear. So far so good, engine sounds noisy but still works. But if I then slow down, until 40-45 km/h and then accelerate again, the 4th gear is still recommended although not even really power The actual question is: Who should I trust more? The engineer, who programmed the gear recommendation or my feeling? Is it no longer harmful to drive a petrol engine underpass? On which factors is such a gear recommendation dependent? Unfortunately, in the case of cars, I am a completely unwritten sheet, so the explanations please in generally understandable statements. That would be very nice ?? Many thanks in advance!

Hello, I got the Tuning-Tec LPSE28 headlights for my Seat Ibiza 6L. The installation was absolutely problem-free, everything fits plug & play. I really like the look, especially the LED daytime running light does something neat. However, I have a problem with the height adjustment of the headlights. There is only one adjustment screw, with which I can change the side adjustment (left/right). I can not find a second adjustment screw for the height. d of you the same headlights and can tell me how I can mechanically adjust the height of the light? Would be great if someone had a solution!