Hi, for the purpose of installing a seat heater (two surfaces per seat!) in a Smart ED 451 (BJ 2012) I am looking for ignition plus (clamp 15) in the footroom area, which is quite high secured (> 200W) and where a simple ring cable shoe can be put on. Is there a good place? BTW, how much electricity can I carry over a power thief? Thank you in advance!
Category: Smart 1 & 2 Forum
-
Brabus 2009 144K Km Unconcerned buy?
Would my 2nd Smart, however, be the first Brabus.https://www.autoscout24.de/…/…c100-9554-4040-9ded-1955f5b3f95f?… we don’t have to talk about warranty if it only requires 350 € more. But what do you have here for an impression? my convertible ran funny in front of it until it made acquaintance with a full-grown hazelnut. what put me here is how does it look with the Brabus motor from ? how durable is the ?
-
Smart 451 , Ratters when climate is on
Hello community, at the Smart 451 MHD (52kW), built in 2009, my father rattles it when the climate is on. The noise comes from the front. As soon as you switch it off, the noise goes away shortly afterwards, not immediately, but a short time later. Can it be that the fan has one away? Sporadic the rat goes away also times. Thanks in advance. Greeting x2max
-
Smart turn signal problem …….Questions to the experts
Hello I have a problem with a smart of the turn signals Spins it flashes in the approximately double frequency. ALL bulbs are however whole (hi re was broken and I have made them new) When I press the warning flash switch everything is normal All (6) lamps flash and also the frequency is fine as soon as I want to flash “normal” it goes about twice as fast as normal. Do I have to reset anything ????????????? or one had the problem before where can I get a schematic of the turn signals. Smart City-Coupe MC01 0.6ccm EZ:2/99 Key number to 2:7009 to3: 300 Thank you for your help Grüeß Uwe
-
SMART 451 Heating cold
Hello Smart friends, I’ve been having a problem with my Smart fortwo for 2 days now. the following to the vehicle: Smart Fortwo MHD 61PS (Benzin) Bj 4/2011 without climate and 52000km. I did the following action 2 days ago: Changing the rib belt without opening any cooling circuit and without having removed any plugs. Alternator tightened back, strap old down and strap new on it. Running direction etc. everything noticed and also voltage checked. Engine runs 1a and also MHD works great. I don’t know if it can be related to it, but the following problem: My heater only blows cold air out of the ventilation. There’s no difference between warm or cold. Engine runs 1A and does not overheat either. Cooling water in the tank is also hot and without excessive overpressure. Heating blower works perfectly in all stages, but only cold air comes up. I have read similar problems with air in the heating circuit. I can’t shut out because I’ve changed nothing on this and the compensation tank is both since 20km. Heating blower works perfectly in all stages, but when there’s no hot air is used.
-
Squeaking during cold start – 451 MHD
Hello guys I drive a Smart 451 MHD 70500 km on it I don’t know if it’s cold season but when I turn on my engine always comes a squeaking after 10 minutes stops that is normal ??
-
Navi & GPS antenna installed
Good day together and I bought a Navi from Bosch. Now I want to install the radio now unfortunately I do not know where I should install the GPS antenna on the radio. Unfortunately I am a newcomer in this respect hope you can help me. Greetings
-
Smart Coupe 451 CDI 45 hp (built in 2007) no longer switches in rain
Hello Together, my Smart unfortunately has a problem. When it rains, it no longer switches. He stops in the third gear, and when I run a traffic light, the engine goes off. The whole thing announces itself, by shortly before the gears are switched up and down. If I then wait a bit (until it is a bit dried under the vehicle??), it can be switched again. With dry road everything is in best order. After some research I have installed a new switching actuator. The problem then actually disappeared for about 3 weeks and I thought about it in safety:-). But far missing, it is there again. Of course, the new switching actuator is now also defective, but I don’t think that’s quite likely. Before I changed the actuator, I thought at first of all to the transmission cable tree, I did not change it yet and also did not measure it. Would you like to stand next (date in SC on January 03). The coupling was also exchanged a few months ago, therefore I don’t suspect that there is a small defect!
-
forfour does not accept gas / indicator light burns
My smartie (forfour 1.1, 75 hp, 68tkm) is worried for the first time. It has already happened twice that he hardly reacts to gas commands after starting and only comes very hesitantly on about 2000 tours when I am idle – when I go through fully. Driving – but with restrictions. After turning off two times – then everything goes normal again. Control light burns for two days, then goes out. I haven’t read fault memory yet – inspection is up anyway. Someone has an idea or similar experience? I type motor control/electronics/turning number sensor or something like that…
-
Unfortunately I scrapped my Smart MC 01 on weekends Year of construction 1999
Need help for purchase recommendation Model 451 petrol tanker .Thanks in advance.driving power approx.8000-10000 km per year mainly city.Climate indispensable.used as a second car, mainly the engine variant is very reliable. P.S The scrapped Smart MC 01 has a very reliable intact replacement motor which was installed by Fismatec 11.2008 and has survived without problems.Quality that pays off.