Blog

  • Higher purchase price but lower leasing rate

    Just look at autosuch.de the VW Sharan. I came across a few offers: A) Purchase price 26,954 42 months, 12,500 km, 100 Euro Deposit effZins 0.16% returns monthly rate: 294 Euro B) Purchase price 27,880 42 months, 12,500km, 100 Euro Deposit eff Interest 0.18% returns monthly rate: 266 Euro Difference: 42x(294-266)=1,176 (100 Euro Deposit I only took because the rate calculator 0 Euro does not always accept immediately) Now I ask myself why A) with a lower Price price has a higher rate? Does A) assume a lower residual value? Just see that A is a diesel and B is a gasoline. I would like to negotiate with A and come to the level of B. A and B are two different VW car dealerships. Can each dealership store its own values with the rate calculator? Otherwise, the same purchase price and the same information would always have to come out of the same rate, right?

  • Cancellation BMW Bank ongoing financing

    Hello, I have noticed that it is possible to revoke ongoing, even completed financing due to incorrect wording. According to ECJ 26.03.2020 this should be possible. Do you have experience in this regard? Mfg

  • Rex 50 always goes out

    Good evening, I bought myself a Rex 50 2 weeks ago to drive to work with it. Only when I turn on the scooter, it runs very weak. When I then give gas it usually goes out. I bought and installed a new air filter and a new battery. Since I otherwise have less idea of scooter, I don’t know any more. Here are some more data: Rex 50 (50ccm) 2 clock Minarelli engine lying standard exhaust and otherwise everything standart. r say what I can do. Thanks already in advance Kallekup

  • Roller smokes very strong!!

    Moin to everyone!! I would have a problem with which I don’t know any more.. I have a Kreidler RMC E 50 which is from 2008. The scooter smokes after start or if I give full throttle very strong. I would say it is more white smoke and not blue. The spark plug is new and the scooter gets its oil through a hose that in my opinion leads directly to the engine or up to the engine block where possibly an oil pump is on it ?? so I have no idea if it is an oil pump or not, but looks like it.. I can also upload a picture of it if it is desired. To the problems: it is a bit oil under the exhaust to see or. there drips out some oil under the exhaust. knows jmd. maybe further or have there some tips? I have removed the carburettor more often and the gasoline air mixture should also be right, because it is standing very quiet and also with full gas has the “full performance” Thanks in advance LG maxi

  • First inspection scooter 50ccm

    Hello everyone, after the problem with the E-starter has solved itself (it probably had to play everything first, now it works well with the Kickstarter ), I have a question about the first inspection … According to the service plan the engine and transmission oil should be completely renewed here; is this really necessary? Isn’t it enough to have this done only at the next inspection, because after all the scooter has at the end of February maybe 500 km on it (depending on the bet r )), but the 3 months as default are then in any case over. Everything else should be maintained and bolts and nuts fixed and lubricated. I ask this, because I do not agree, for this inspection almost 1/3 of the purchase price to add… the estimate is € 288,-, hello? But I also have to say that the estimate included among other things a new oil filter, air filter, new spark plug and other, which now really not on the service plan as inspection specification z u is found, only that’s why I feel already in advance …… I realize that any damage caused by non-compliance with the inspection requirements is no longer covered by the warranty, nevertheless…what is really necessary? Thank you for your answers Greetings Karin

  • peugeot sv 50

    Good evening, after more than 20 years I bought a scooter again, so far so good, I bought an older one extra so that it runs a little faster, what one reads so run the sv50 ö about 65kmh, my ran at the beginning 47kmh, now runs jer with new weight of dr. pully 55kmh, would like to crack the 60, can someone give me tips? Ahja got a universal exhaust off whether that can be due to it? Thanks and greetings

  • Roller doesn’t start anymore

    We tried to start my father’s scooter, since the battery was empty we tried it over the kickstarter. Unfortunately this also without function. The last time the easy cruiser from Zen drove in December 2019, what could it be now that era no longer starts?

  • Problems after conversion to disc brake

    Evening. Need help!!!! Subject 70s Chevy Nova with 350cui engine. About seven years ago I converted from drum to disc. SSBC conversion kit A123-1. BKV and HBZ did not take out of the kit, but installed a rather inexpensive unit in chrome from Ebay.com. The hoped-for “Aha effect” concerning the braking performance after the conversion, however, remained out at the time. The brake force reinforcement was hardly noticeable…… Since the car is not moving very much, I first lived with it with it. d thought that it could only get better if I switch to a disc at some point in the back. That’s what happened last year. SSBC conversion kit A125,compatible with the front disc brake! The previously installed,traditional,old-style proportional valve replaced me with an adjustable one by SSBC (A0730). I try to adjust a few pictures. As far as everything is chic,but all without any striking success. Despite meticulous, multiple venting incl.”bench bleaching” like the Ami the venting The more serious problem that I have after the last ventilation excesses, however, is that I already have four hot brake discs and grinding noises after one kilometer of test drive with careful braking manoeuvres – i.e. constant brake pressure. I can turn all the wheels when the brake is cold. I’m about to light the car. Where is the fault? My guess would be that if the brake is cold, I can turn all the wheels. I’m about to light the car. he Brake Booster/Master Cylinder Unit just looks good, but scrap is,not compatible,the Brake Booster is a dummy or whatever…….Thank you in advance for constructive tips. Greetings,Thomas

  • Mustang Gen.5 (2009) Change Shaker 500 for 2Din Radio. Voltage regulator?!

    Hello community, I would like to exchange the shaker 500 in my 2009 Mustang for a Kenwood DDX4018DAB (2 Din Radio). I ordered the aperture, including the adapter cable. Now see in this Do It Yourself tutorial that an additional 12V/5V voltage converter is needed?? Is this true?https://www.autoextrem.de/…/ Maybe someone has already done the conversion and can say if it is right. Some say so, others so.. Greeting Tim

  • Helmet + pants

    Moin! My textile pants by Vanucci tweaks a little above (yes)… Unfortunately, I can’t find a label with the exact name in my pants. Do the trousers and jackets of a manufacturer (Vanucci) always fit together? My Nolan xy has also come a bit into the years and very loud (wind noises). Can someone recommend me a quiet helmet? The one or other manufacturer has definitely put his focus on it or? Thank you!