MOTOR-TALK

Blog

  • Escort clx gas problems and hissing from the exhaust

    Hello together, have the following problem I’m just normal as usual with the car on the highway with an average of 160 driving at once I notice a strong power drop and a hissing from the exhaust or from the region where the exhaust is located. If I don’t give a gas the engine is quite normal. Faster like 130 I can’t drive now let alone uphill I have to switch down to the 3 gear so I can get up to some extent. I have to say the car doesn’t belong to me but to my girlfriend and I don’t have any idea of cars either. Maybe someone has an idea what it might be? Ps: Guilty people that there are so few punctual characters in here and that the gramatics is so bad but had to write it with an iPhone because I don’t have a pc here. Greeting Dennis

  • Buying Audi 100

    Hi, I need your advice. I was offered an Audi 100 2,3E Quattro type 44q. Year of construction 1988, approx. 260tkm run, hu + au until 1/07, ZV, servo, ABS, 5speed transmission, front of Audi 200, exterior colour white, AHK, winter wheels on steel rim sommereifen on LM rim from Audi. Vehicle has a small dent under the rear back light, but this is only a beauty error. Vehicle is to cost 1000 Euro. What do you think of the offer. What do you think about the mileage of the vehicle. verse work on the Audi has been made like oils, brakes, candles, all belts. Thanks already in advance for your help

  • Can I just screw this Iridium Zünkerze into my Kymco Super 8 2 clocks and drive it?

    Hello you, I have a Kymco Super 8 2 timer LC2U91000… which doesn’t start in the rain or at all. If it hasn’t rained, it starts on a pusher at the E-starter, even at -5 degrees. Only the rain he doesn’t like with the Autostartpilot it starts then finally, if you inject a bit into the air filter. But it’s not a real solution. I bought a spark plug now: NGK BR 8 HIX usable for: B8HS, BR8HS, BR8HSA Zündke rze Iridium The operator’s manual says: NGK BR8HSA spark plug, which is now also in it. Can I use the Iridium spark plug without causing it to harm my scooter in the hope that it will start better in the rain or after I drove in the rain the next day? An acquaintance of mine said that he would be careful there, not that he gets a piston eater or other damage. Thank you and good start in the week you all

  • Experience with Voge Roller 125

    Good morning, with an acquaintance is soon to buy a new scooter, a dealer has recommended us the Voge 125, which would be almost identical to the Honda PCX. Does anyone have experience with the brand Voge ? I know that it is a Chinese, but that doesn’t mean anything, meanwhile they come on the market with good quality. I am also familiar with the Voge is imported via MSA, so we have already had good experiences, as with our dealer where we already have some scooters. with new brands, however, you are a little careful. Greetings Harry

  • What is the normal operating temperature of the Piaggio hexagon 125 lx (2 bar)

    Servus I recently created a Piaggio hexagon, since the temperature meter flutes have gone to me then bought an electronic temperature meter from koso. Now I wanted to know what such normal temperatures are so from when the engine gets too hot. The scooter is completely original except for a 21mm dellorto carburettor because the old was defective and an open air filter Thanks already for the answers. (Added a picture)

  • The ignition of the Peugeot Kisbee RS 2019 does not work.

    Hello all, I held the spark plug against the cylinder head, but there was no spark. I tried two other spark plugs, but it still doesn’t work. The scooter (Peugeot Kisbee RS 2019) cracks, but has no spark. Could that be on the rear light/brake light? I noticed that the brake light is not on when I operate the brake lever. I changed the outlet valve myself, and that worked well. I didn’t have a CDI, but a CDI. ECU. I measured the ignition coil (bobine) and the alternator (stator), but I don’t know where the error is. Does anyone have any idea what it might be about? Thank you!

  • Who has converted from H7 to LED?

    Hello together. For my SLK with the bad H7 lamps there is approval to install the LED lamps from Osram.https://look.ams-osram.com/…/…Night-Breaker-H7-Vehicle-List-EN.pdf I implemented immediately, result is as desired. Only one problem still exists: The car reports errors, probably because of other resistance or current consumption. The constantly thinks lamp is defective although at the front everything becomes daylight. Unfortunately I find with Osram no indication if and which ballast components he Question: Has someone already solved the problem here or am I (again) the first?

  • Problems with Audi 80 B4 ABK

    Hi, I have the following problem with my Audi when I stand and the engine is idle (800U/min) and I move the accelerator slowly, it breaks me at 1200U/min again at idle speed, I am over this point away, everything is normal again. no false air throttle flap poti and DK seal new DK cleaned idle stability valve cleaned injection valves resealed error memory read out, no entry intake air temperature regulator renews coolant temperature Ratursensor for motor control unit renewed I’m as good as at the end with my nerves. Does anyone else have this phenomenon or is it normal at the ABB? Unfortunately, the Sufu did not bring anything to this topic either.

  • How does your Audi Quattro drive me differential lock on snowy road so?

    Hello Audianer, I wanted to ask how does your Audi quattro behave (with possible differential lock on) if the road is really snowy? So especially if the road is slightly uphill and the road is covered with snow? Does the wheels slide completely through? Or does it go forward as if it were nothing? I had a spot today where I almost didn’t come away with my golf with front wheel drive. And once again I needed a few seconds at the ampel before I had to go from the place came, gaaanz slowly hit by it. What do you look like?

  • B4: Why can rear seatrests be locked via ZV?

    Moin, have a smart question again: Why is it possible for the B4 but model 2.3 E to close the back seat backrests? So that you can no longer fold them over? And what’s behind it, I just don’t understand the meaning. Nobody breaks open a car to fold the seats or? If someone could explain it to me with more insight…. interests me just times^^ Greeting