Hello you love I recently bought a roller of the brand HSUN, model HS150T-2. The scooter ran at handover, but was empty from the filling level. So on Friday I went to the local Raiffeisen gas station to fill up. I refueled Super Gasoline, no E10. The next day, after driving home he jumped and drove, but as soon as he was a little warm he has speeded down. What do you think it might be? I tap on the spark plug, but I’m not sure what it is. I’m very grateful for every tip. Best regards, Patrick PS: it’s a GY6 engine.
Blog
-
What to consider with new cylinder
Servus.https://youtube.com/shorts/pt90Lz5Z0_M?si=fmeDGFsz44-zaj9a Have a Koblenfress, which was to be expected if you offroaded 1000km without air filter. I took my whole engine apart and cleaned it up. But because a lot of the engine has to be cleaned especially with the crankshaft. My plan would now be to tip diesel in and let it work on and then blow out with brake cleaner. I ordered a new cylinder so that it will run again. What so I’ll pay attention to the installation? So I’d like to lubricate it with motor oil and then install it. Anything else?
-
Only 3 bar compression despite everything new
Hello everyone, my sfera spins the whole time. She ran about 2 months after I bought her. She had more problems with the start and ran a little too fat. Meanwhile she doesn’t work anymore. Also not with starter spray. I got a compression knife. I connected it and started it. Unfortunately I get only 3.5 bar pressure. That’s way too little. The cylinder and the head are new also the rings. Vllt I made the mistake and after the installation h frequently driven directly with full throttle? But I think it can’t be because of it. After the pressure measurement I left it then the pressure dropped by about 0.5 bar after that but no longer. What can this be about? Do you have ideas?
-
MINI lower value loss? – does not apply to CM JCW
Hello Minigemeinde, after 2 years I drove my leased countryman John Cooper Works to and wanted to exchange for a economical BMW (530xdrive diesel). Basically this then goes as follows: the MINI is evaluated and bought out from the BMW/MINI used car center at the BMW Leasing Bank. The residual value at the bank new price minus leasing rates must of course be as close to the rating as possible otherwise it will be expensive. It is possible that after 2 (instead of 3) years of one However, there was already positive experience, since the running line was lower and the residual value better. However, that was a Mercedes E-Class. Back to the CM: The offer then calculates as follows: New price 46,000€ 35,000km per anno makes after 2 years 70,000km. (contract over 3 years therefore total after expiry 105,000km) Leasing rate so far 24 x 620€ (640 inclusive service) makes around 21,000€. The bank wanted 2 8,000€ so a difference of 3,000€ between rate and trigger sum. As far as can still be done to get out of the contract after 2 years. Funny was then the rating by MINI used cars: 18.00€ Exactly! The residual value is 10,000€ below the book value. For this I like to drive another year 😉 so who buys a JCW makes new after 2 years directly 60% loss. Since my after 3 years has over 105Tkm on the clock it probably becomes unfor saleable for over 15,000€. I know a few others who have got rid of a brought MINI very hard at a good price. So the supposedly very good value preservation is not so good depending on what it is. To get rid of the risk of loss of value is worth leasing or these 3 because of financing also for private. Then I can still think about what I do. would I be interested in how your experiences with the used value are?
-
Cooper s Bj 2005 Wheels/Exhaust
Hay people, I bought a Mini Cooper s today Bj 2005 and wanted to ask you now some questions: – 18 inch rims are no problem with deeper springing or ? Ca 30mm deeper – which ET I need the rims are finally with the kotflügen – which tires I need at 18 inch (dimensions) – which exhaust from kat can you recommend should make a nice dull sound (max 1000€) – which rims you can recommend I thought of OZ (max 140€ with mature) Grü ße and thank you already
-
Put money in the R53 or not?
Hello together! I’m just about to ask if I should continue driving my Cooper S R53 or not. So my Cooper S was built in 2003 and has almost 140,000km on the hump. The brakes are starting to squeak, the climate compressor is defective, just my cooling water compensation tank was broken (renewed) and at the end the cylinder head seal (????) is a bit damaged. My friend said that the seal is still going on but I am stronger on the oil consumption The servo pump was also renewed about 3 years ago. The master said that I should look around for a new car. Now I asked myself the question: If I have to repair the mini completely again and drive it as long as I can or buy something else? How about engine damage etc.? Since I am quite a layman, as far as the technology and all the problems are concerned, I wanted to ask you for advice. Because 12 years and 140,000. km i I’d like to look around for an A4 Avant or A5. But I really hate to separate myself from my little fun mobile!! Thank you in advance! Nice greeting from Hannover.
-
Harman Kardon Soundsystem .
Hello, I’m new here in the mini forum. After almost 4 years with my A3 convertible I play with the idea to switch to a mini convertible. In the A3 I have the Bose sound system. But find this only to a limited extent recommended, it sounds only very rough dissolving, but is rather for sound pressure without bass. So mass instead of class. What I’m looking for is a fine resolution, which is also suitable for classical and jazz muck. Do I get a better goal with the Harman Kardon system?
-
407 2.0 HDI engine leaves sporadic after starting
My Peugeot 407 2.0 HDI Bj. 2005 starts sporadically after starting again. The engine starts, but then it runs unround and then just goes out. If you start a few more start-up attempts then it usually starts again after a few try and then it runs stable and you can drive. During the day it is to be used again and the engine doesn’t go out any more, if it doesn’t run out again. But when the car is standing overnight, the problem occurs more and more often in the morning.With a YouTube video with the phenomenon:http://youtu.be/2BQVFSLa3lc I was already 3 times in a Peugeout factory saddle, but there he always jumped and no error could be read. Once he did not jump at all until the battery, from the start-up attempts, was empty. After that the battery was recharged and tested and there could be no fault of the battery/E On assumption I didn’t want to have any parts replaced, since no one could assure me that the error has been fixed after possible fuel pump replacement. However, some plug connections to the Krafstoffpump have already been changed, but this did not fix the error. Maybe one of you once had a similar problem or has an idea what it could be. Thanks already for any help! Many greetings Christian
-
Radio remote control defective
Hello everyone, after a clutch repair in the workshop the radio remote control of my 406 2,2HDI FAP Break no longer works. I thought the thing is quite simple, they have the FZ-battery stuck off too long, and you only have to learn anew. It is in the operating instructions. Ignition OF Ignition A press immediately on the big button. Ignition switch off however not possible. Battery changed in the key also did nothing. The free workshop also tried it and was just as ni In order to check if the key is correct I have done the following: put into a TV short antenna. Keys held next to the TV, UHF, I think it was set to 433Mhz. Then you can see that the key after holding down the big button for a few seconds sends out some packet. So the key seems to be OK. Does anyone have an idea what else to do. Where is the ECU actually sitting at the 406 2.2HDI FAP Break?
-
NG only turns up to 3200 rpm
Moin, have problems with my Audi Cabrio NG! The engine only turns up to 3200 rpm! When it reaches 3200 rpm it starts to boom and starts to shake! Last year the Lamdo probe was made new! Have already cleaned the crankshafts and the throttle flap but no improvement! I already drove with clamped Lamda but also no improvement! Spark plugs , cables and ignition distributors are new! What else can that be! Greeting Stefan