MOTOR-TALK

Blog

  • Pressing depth

    hello all together have ordered me now because of the abwrakpremie nh a3 sportback and wants to buy now also rims on it now interests me the maximum press depth on 18 inches can man take back a smaller press depth? wanted to buy the ib 5 rims with it already who experiences and I have no idea what to take for tires ps the car should not be laid down and also no wheelboxes pulled and the tv should also play with me I say already thank you mfg thomas

  • Get what frame? Zx6r

    Hello, I had a driving accident with subsequent fall on the right side. Luckily not much happened to me, the accident should not be possible here either. On the motorcycle the oil cooler was pressed in front, the pulpit was naturally broken in a place, the gear switch was broken and you could, because the disguise is not fully tilted anymore. I drove the machine still test-wise (of course before oil cooler, gear shift changed and the disguise sow It was all right. However, the panel at the bottom simply didn’t fit, so I changed the following: Fork completely fork bridge at the top and bottom Changed axle Changed mudguard at the front And as said oil cooler and gear shift. Unfortunately, the panel still doesn’t fit at the front, it comes to the front. The fixed point on the housing on the left(Kupp) It is strange that nothing was bent from the things I changed, i.e. fork, fork bridge, etc. Does everything look straight. Do I make a mistake of thinking? Or are the aluminum frames simply very soft, softer than the fork and the bridges? With a photo of the distance to the oil cooler. I would be pleased about a few opinions. PS: how expensive is it to change the frame? I am clear that there is nothing wrong with this. , actually I have to build the whole motorcycle from right to left. But I didn’t have to do such a big conversion yet. I’ve already changed wiring harness and how to work on it can be seen clearly more.

  • What fuel are you fuelling?

    Servus people, what are you fuelling with your motorcycles? A friend thinks I should fill Ultimate or Shell V Power and will notice a difference to E5. Of course, the higher fuel is due to the higher octane count and will certainly do the engine better but do you really notice a difference? My SV650 (2020 model, throttled to 48 HP) would even be capable of E10. So far, however, I only refuel “normal” fuel so E5. I am still of the opinion that this is a little bit of a matter of faith. Is that what you’re talking about? Is there money out with the most expensive gasoline or sometimes good? LG, Manu

  • Motorcycle after cruciform ligament crack

    Hello all, this will be my first post in the “Motorcycle-area” I hope I have chosen the right subforum for this question. And that’s when I came to the taste of wanting to make the motorcycle driver’s license a while ago. Briefly to me: I am 22 years old and have been driving my driver’s license for the car for 5 years. As I said, though late, I developed a passion for the bikes and would like to make the A2 appearance. But now I have unfortunately the front cruciate ribbon ris I know that you can’t say how long the healing process will take, because it is different for everyone. Maybe there are a few experiences of people who might have had such an injury. It’s roughly said you can drive again after 4-6 weeks. Would that be comparable to a motorcycle? So in a few weeks I could already make the theory for the A2 appearance and then for example end of March m I am aware that every course is different. Nevertheless, I would be happy about your experiences and reports. Best regards Dominik

  • Problems with light due to installation

    Hi when I turn my system full on then you can see in front of the headlights that they don’t get the right juice (flattening at the bass) you told me that in my car a continuous current cable is missing so that I can also install it myself have one that makes me 30 euro or is that due to something else ???? Have an audio 80 b4 bj 12/92 90 ps

  • Mercedes S-Class Extreme tyres

    Hello together. I have a w126 420sel (HA level) would like to mount the following marking: Tyre size front: 10J x 18 245/40ZR18 Tyre size rear: 11J x 18 285/35ZR18 Each have the ET35.I know that my car is not allowed over et30, otherwise it would grind from the inside, that is et20 or so is ok.My question is, can I also have et-? Or does it always have to be in the “plus range”?? Have thought if it should fit… At the front I would like 20mm discs per page or better take 30mm per page and at the back too… Or is it wider?? Have I seen 60mm slices per page This looked really brutal… What do you say, how should I – which distance disks to install??? Thanks already in advance.Ps. Please no doofen remarks, who has anything against it, can also go to the w124 forum.

  • Some technical problems w126

    Good evening.. Have some problems with my 126er again, it is about the Fzg. 1. The gearbox makes so funny noises during the ride… As if there was a wheel spinning with… And sometimes it sounds like something is grinding on the gearbox…. 2. If I drive around the corner or even over shaky roads then such a crackling noise comes from the back right… Is really annoying… And in rainy weather it’s not there- the noise… Especially to h If I drive on petrol, the car runs restless.Oil pressure changes up and down by about 0.5Bar , is in warm condition on D very rarely under 1.5Bar, think that is I.O. But he is just restless on petrol… on gas he always ran very calm… 4. Every now and then at the cold start the car hardly takes on gas… But if I take the foot lightly off the gas, he somehow has me hr Power…so exactly the other way around… Sometimes I have the problem even in the warm state( 85 degrees), then has no power at all… but the economy indicator is on red… Because I give gas… Aei ug Gas is not the problem! So that’s it for now… Hope you can help me or give me tips…Thank you so much Im vorraus.Mfg, Nice.

  • So guys, finally get some pictures of my S500W220

    …even though now some stony ones will be for what I have done. I like it exactly like it! I have installed the lowering module, which auts at speeds from 30km/h. slightly higher goes to not affect the ride comfort! D.H. the car is only in the stand and only up to max. 30km/h so deep! Then it goes about 3 -4cm high! In addition I have the MAE 3 partial 19inch wheels installed in 10 and 11,5*19 with 245/40 and 275/35 he Dunloop tires. To give the rims enough “playroom” all 4 fenders were pulled a little bit so the rims could completely spring through in the case of exception and thus do not hit on the fenders! Furthermore the MOPF-Sw were installed in the back and at the front of course also (but at the front it happened later and only on the one photo to recognize) the mirror turn signals are still in the trunk. If someone can tell me in detail how to change this would be grateful! So, that was it for now… Have fun with the pictures

  • Buy S 260 or not???

    Hello together! I found a Mercedes S 260 on ebay. First registration 86., 118KW, 158000km, no CAT, almost no extras, but on the photos he actually looks very acceptable from mMn. Lack iss Tip Top and interior like new. How do you see the thing? At 230€ I have the seller already down. 2000€ should also be done. Can I buy the car at the price? How are your general experiences with the S 260 from this time? We worth the car even more? and is it suitable for use with the car. ch as a everyday vehicle? Apart from the 11-… l gasoline 😉 I like quiet interior without squeaking and clapping. Can the 260er fulfill this? Questions about questions 😉 Thanks for the answers already in advance LG Soundfreak31 At the link to the ebay auction (already expired, but I am in email contact with the seller)http://cgi.ebay.at/ws/eBayISAPI.dll?…

  • KAT makes funny noises!!

    Greetings!! I’ve been having a funny sound in the area of the left wheel suspension for about 3 days. It sounds like a RIESIG screw in a pot of Lohse!! It sounds horrible, especially when driving away! ( Drawn sound ) The noise only appears when accelerating. It’s soo loud that you can hardly drive with open windows, even when the window is closed you can hear the noise. From about 50 km/h you can hear nothing, even when speeding up. Have a technni ker (telephone) asked what that might be, he meant that the KAT might have been broken, but is unlikely for me… because the KAT is sitting a little further in the back (under the driver’s seat about….I think I did). I was driving back into a small pebble pile about 1 week ago (that was finer pebbles), and I think that maybe one or two stones in my left exhaust came in..and worked out to the Krummer, and the The technician has denied it that a stone could be the cause. Hope you can help me!!! Thank you in advance. mfg